Input selection and AV connections

Defining the INPUT and OUTPUT sockets so that the television recognises connected equipment. See page 6 for a clear view of the back connection recommendations.

Most VCRs and decoders send a signal through the SCART lead to switch the television to the correct Input socket. Alternatively press the external source selection button B until the picture from connected equipment is shown.

An S in the display e.g. B3S (EXT 3S), indicates the input is set for an S-Video signal.

Input selection

Use the Input Selection if the television does not switch

over automatically.

1Press Bto select B1, B2, B3, or B4 (EXT 1-4).

2To return to television mode press Bagain or one of the numbered buttons.

INPUT signal selection

This specifies the type of signal going into SCART 3 (EXT3) on the back of the television. Please refer to the manufacturers instructions for the connected equipment.

1In the SET UP menu press Q until

AV connection is highlighted, then press R. With S or R select either AV or S-VIDEOas the required input for EXT3.

If the colour is missing try the alternative setting.

AV connection

EXT3 input	▼	AV	▼
EXT3 output	▼	EXT1	▼
Woofer	▼	Int.	▼
Audio output	▼	Fixed	▼

OUTPUT signal selection for SCART 3

This enables selection of the source to output from SCART 3. For example, to record transmissions in stereo from a stereo decoder – connect a stereo decoder to SCART 1 and stereo VCR to SCART 3, then select EXT 1 as the EXT3 output. The signal received through SCART 1 will output directly through SCART 3.

1Select AV connection.

AV connection

EXT3 input	▼	AV	▼
EXT3 output	▼	EXT1	▼
Woofer	▼	Int.	▼
Audio output	▼	Fixed	▼

EXIT :To exit

2Use Sor Rto change the EXT3 output option to:

Monitor = The picture on screen.

TV = The last television programme selection. EXT1 = The picture from equipment connected to SCART 1.

EXT2 = The picture from equipment connected to SCART 2.

EXT4 = The picture from equipment connected to the front/side input sockets.