Toshiba 50PH4700, 60PH6700 owner manual YyDot Defect For USA and Canada, YyGenerated Sound

			IMPORTANT SAFETY INSTRUCTIONS 5
yyDot Defect		For USA and Canada
	The Plasma or LCD panel is a high technology
	product with resolution of two million to six		FCC NOTICE
	million pixels. In a very few cases, you could	This equipment has been tested and found
	see fine dots on the screen while you’re
		to comply with the limits for a Class B digital
	viewing the TV. Those dots are deactivated
		device, pursuant to Part 15 of the FCC Rules.
	pixels and do not affect the performance and
		These limits are designed to provide reasonable
	reliability of the TV.
		protection against harmful interference in
yyGenerated Sound
		a residential installation. This equipment
	“Cracking” noise: A cracking noise that
		generates, uses and can radiate radio frequency
	occurs when watching or turning off the TV
		energy and, if not installed and used in
	is generated by plastic thermal contraction
		accordance with the instructions, may cause
	due to temperature and humidity. This noise
		harmful interference to radio communications.
	is common for products where thermal
		However, there is no guarantee that interference
	deformation is required.
		will not occur in a particular installation. If this
	Electrical circuit humming/panel buzzing: A
		equipment does cause harmful interference
	low level noise is generated from a high-
		to radio or television reception, which can be
	speed switching circuit, which supplies a large
		determined by turning the equipment off and
	amount of current to operate a product. It
		on, the user is encouraged to try to correct the
	varies depending on the product.
		interference by one or more of the following
	This generated sound does not affect the
		measures:
	performance and reliability of the product.
			- Reorient or relocate the receiving antenna.
yyTake care not to touch the ventilation
			- Increase the separation between the
	openings. When watching the TV for a long
			equipment and the receiver.
	period, the ventilation openings may become
			- Connect the equipment to an outlet on
	hot. This does not affect the performance of
			a circuit different from that to which the
	the product or cause defects in the product.
			receiver is connected.
	Preventing “Image burn” or “Burn-in” on your TV		- Consult the dealer or an experienced radio/
			TV technician for help.
	screen	This device complies with part 15 of the FCC
		Rules. Operation is subject to the following
		two conditions: (1) this device may not cause
		harmful interference and (2) this device must
		accept any interference received, including
		interference that may cause undesired operation
yyIf a fixed image displays on the TV screen for		of the device.
		Any changes or modifications in construction of
	a long period of time, it will be imprinted and
		this device which are not expressly approved by
	become a permanent disfigurement on the
		the party responsible for compliance could void
	screen. This is “image burn” or “burn-in” and
		the user’s authority to operate the equipment.
	not covered by the warranty.
yyIf the aspect ratio of the TV is set to 4:3 for a
			NOTE TO CABLE/TV INSTALLER
	long period of time, image burn may occur on
		This reminder is provided to call the CATV
	the letterboxed area of the screen.
		system installer’s attention to Article 820-40 of
yyAvoid displaying a fixed image on the TV
		the National Electric Code (U.S.A.). The code
	screen for a long period of time (2 or more
		provides guidelines for proper grounding and, in
	hours for LCD, 1 or more hours for the Plasma
		particular, specifies that the cable ground shall
	TV) to prevent image burn.
		be connected to the grounding system of the
		building, as close to the point of the cable entry
		as practical.

ENGLISH