Toshiba 84LM9600 manual FCC RF Radiation Exposure Statement, 1ttih*~1~I~r&z1~m11~~~=m

~F*~~q:OJI 1}PJ im5m~f~Jt.l~±~1'

1~H!H3~1J]I!~I* JJO:*Ih*~~~®:

~~~tz~~·l·i&rJJrm

2)~+~{~

1ttih*~1~I~r:&z1~m1'1~~~=m

mfi::~~~=ft~~5-5nim1§ :*~~IJ!~ =fj~IJ!~B~~ B!ri.tW{~ffl~ MLc~~~ 1m=fj~B~n1~r.IHr.l1~fflWJI.W15'5nim

{§I t~11X~1§51i:~J[:AE1'F~Z1m$JR~

®1§1ttrJJ*~1~I~t!~.w~~-g-5n:®

{§~I~ f~~:&.G~ffl~)$:,~~1 ·1·1~r:&~~1ooz=fj~

(3)ANATEL Statement (Para Brazil)

Este equipamento opera em carater secundario, isto e, nao tern direito a prote~ao contra interferencia prejudicial, mesmo de esta~oes do mesmo tipo e nao pode causar interferencia a sistemas operando em carater primario.

(4) Federal Communications Commission (FCC) Statement

You are cautioned that changes or modifications not expressly approved by the part responsible for compliance could void the user'sauthority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules.

These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-. Reorient or relocate the receiving antenna. -. Increase the separation between the

equipment and receiver.

-.Connect the equipment into an outlet on a circuit different from that to which the receiver is connected

-. Consult the dealer or an experienced radio{TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1)this device may not cause harmful interference, and

2)this device must accept any interference received, including interference that may cause undesired operation of the device.

FCC RF Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End users must follow the specific operating instructions for satisfying RF exposure compliance.

(5) Industry Canada(IC) Statement

This device complies with RSS-210 of the Industry Canada Rules. Operation is subject to the following two conditions:

1)this device may not cause interference and

2)this device must accept any interference. Including interference that may cause undesired operation of device. This class Bdigital apparatus omplies with Canadian ICES-003

Avis d'IndustrieCanada

Cet appareil est conforme anorme CNR-210 des reglements d'Industriecanada. Son fonctionnement est sujet aux deux conditions suivantes:

1)Cet appareil ne doit pas provoquer d'interferenceset

2)Cet appareil doit accepter toute les interferences. y compris celles pouvant entralner son dys- fonctionnement.

Cet appareil numerique declasse Best conforme aIa norme NMB-003 du Canada.

IC Radiation Exposure Statement:

This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment.

NOTE: THE MANUFACTURERE IS NO TRESPONSIBLE FOR ANY RADIO OR lV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT.

SUCH MODIFICATIONS COULD VOID THE USER'S AUTHORI1Y TO OPERATE THE EQUIPMENT.

Avis d'lndustrieCanada sur !'exposition aux rayonnements

Cet appareil est conforme aux limites d'exposition aux rayonnements d'IndustrieCanaca pour unenvironnement non controle.

REMARQUE:

LE FABRICANT N'ESTPAS RESPONSIBLE DES INTERFERENCES RADIOELECTRIQUES CAUSEES PAR DES MODIFICATIONS NON AUTORISEES APPORTEES APPORTEES ACET APPAREIL.

DE TELLES MODIFICATIONS POURRAIT ANNULER L'AUTORISATIONACCORDEE AL'UTILISATEUR DE FAIRE FONCTIONNER L'APPAREIL.

COFETEL(Mexico)

La operacion de este equipo esta sujeta a las siguientes dos condiciones:

(1)es posible que este equipo o dispositivo no cause interferencia pe~udicial y (2) este equipo o dispositivo debe aceptar cualquier interferencia, incluyendo Ia quepueda causar su operacion no deseada.

(6) CE Statement

1)CE conformity Notice

LG Electronics hereby declares that this product is in compliance with the following Directives.

R&TTE Directive 1999/5/EC

LOW VOLTAGE Directive 2006/95/EC

The products described above comply with

the essential requirements of the directives

specified.-

This device is 2.4 Ghz wide-band transmission system, intended for use in all EU member states and EFTA countries.

European representative:

LG Electronics Inc. Krijgsman 1,

1186 OM Amstelveen, The Netherlands

2)CE Notified Body statement:

This is a Class Bproduct. In a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate measures. Explosive device proximity warning-Do not operate a portable transmitter (such as a wireless network device) near unshielded blasting caps or in an explosive environment unless the device has been modified ment unless the device has been modifiedcaps or in an explosive environment unless the device has been modified to be qualified for such use. This CE marking is valid for EU non-harmonized telecommunications products R&TTE Directive (1999/5/EC) issued by the Commission of the European Community.

3)Certification Marking

CE

(6-1) DEUTSCH EU-Konformitatserklarung:

LG Electronics erklart hiermit, dass dieses Produkt den folgenden Richtlinien entspricht:

R&TTER-Richtlinie 1999/5/EC Niederspannungsrichtlinie 2006/95/EC

Die oben beschriebenen Produkte entsprechen den grundlegenden Anforderungen der angegebenen Richtlinien.