Connections and controls
A wide variety of external equipment can be connected via the sockets located on the side of the TV.
Whilst all the necessary adjustments and controls for the TV are made using the remote control, the buttons on the TV may be used for some functions.
Standby Button
!
to at
DO NOT | connect | equipment | |||
| 2 terminals | ||||
both | the | side B | |||
| . |
|
| ||
|
|
|
| ||
|
|
|
|
| |
the same | time |
|
| ||
|
|
| |||
☛ |
| |
DO | ||
| NOT connect a | |
standard | ||
AND | video cable | |
an S- | ||
EXT 2 | Video cable to | |
at the same time. | ||
| ||
RED – Standby
Green – On
Switching on
If the
To put the set into Standby press ion the remote control. To view the TV press iagain. The picture may take a few seconds to appear. Standby should only be used for short periods of time.
To set up the TV you will now need to use the
The menu bar at the top of the screens will show five different topics shown in symbols. As each symbol is selected by pressing the Sor Rbutton on the remote control, its respective options will appear below.
To use the options press the Q button on the remote control to move down through them and Sor Rto select the required choice or adjust a setting. The functions of each menu are described in detail throughout the manual.
Using the controls and connections
To alter the volume press — j+.
To alter the programme position press eFf.
When connecting mono sound equipment to EXT2, connect the audio output of the equipmentto the L(Mono) socket onthe TV.
To select the Input, press Buntil the display shows EXT1 as described on page 10. The TV will automatically sense the type of signal.
Please always refer to the owner’s manual of the equipment to be connected for full details.
7