Toshiba 26AF45C appendix Using the Remote Control, To control a DVD player

Using the Remote Control

To control a DVD player:	Power
Program the remote	Input (TV)
control to recognize the	Display
	Mute (TV)
brand of your DVD player
	Number
(see “Programming the	buttons
remote control to operate
your other devices”
below). The buttons	DVD
shown at right will then
	Pic Size
control the DVD player.
Press “DVD” first.	DVD MENU
	1/2/3/4

Volume +/– (TV)

ENTER

DVD controls

DVD Skip/Search J(/)K

Top Menu

DVD Clear

Programming the remote control to operate your other devices

This remote control is pre-programmed to operate most Toshiba satellite receivers, VCRs, and DVD players. To control a non-Toshiba device (or a Toshiba device that the remote control is not pre-programmed to operate)

1.Refer to the code tables (on pages 13 and 14) to find the corresponding code for your device.

If more than one code is listed, try each one separately until you find the one that works.

2.If you are programming the remote control to operate your:

•Cable TV converter/satellite receiver: Press “CBL/SAT”.

•VCR: Press “VCR”.

•DVD player: Press “DVD”.

3.While holding down CODE, press the Channel Number buttons to enter the three-digit code for your device within 10 seconds.

Note: If you do not enter the code within 10 seconds from step 3, or if you enter the wrong code, this operation is canceled.

4.Point the remote control at the cable TV converter/satellite receiver, VCR or DVD player, and press POWER to test the code.

•If the device responds, you entered the correct code.

•If the device does not respond, repeat steps 1–4 using another code.

5.Press “TV” to control the TV.

For future reference, write down the codes you used:

Cable TV converter/satellite receiver code ______________________

VCR code _______________________________________________

DVD player code __________________________________________

CODE

Channel

Numbers

TV

VCR

DVD

CBL/SAT

Notes:

•When shipped from the factory, the remote control is set to operate your TV.

•Each time you replace the batteries, you must reprogram the remote control.

•Some newer VCRs are capable of working on either of two remote codes. These VCRs have a switch labeled “VCR1/VCR2”.

If your VCR has this kind of switch and does not respond to any of the codes for your VCR, set the switch to the other position (VCR1 or VCR2) and reprogram the remote control.

12

J3V50121A(E)_P07-17.p65 12 30/06/2005, 5:07 PM