Setting Jumpers

The following steps must be performed to properly install your DVD-RAM.

●Set drive’s jumpers

●Connect audio cable

●Attach IDE BUS cable

●Connect power cable

●Mount DVD-RAM

●Install CyberLink PowerDVD™ software (used for viewing DVD movies)

●Install VOB InstantWritesoftware (used for recording CDs)

The mode select jumpers are six (6) straight angle pins located on the rear of the DVD-RAM. By placing a jumper on the pins, you can select the following func- tions:

CS: – Drive is configured using host interface signal CSEL

SL: – Configures drive as Slave

MA: – Configures drive as Master (default mode)

C S M

S L A

Mode Select Jumpers

In most installations, jumper should remain in MA (Master) position (factory default). It is recommended that you install your DVD-RAM only on the second- ary IDE BUS. If you are installing on primary IDE BUS, your hard drive would then be the Master, and you should set your DVD-RAM to the Slave position (SL).

PLACING DVD-RAM INSIDE YOUR COMPUTER

Now that you have set your drive’s jumpers, you are ready to install your DVD-RAM inside your computer.

☞IMPORTANT: Disconnect power from your computer system before be- ginning installation.