Pioneer DV-610AV-S 
, , POWER-CORD Caution, Important the Moulded Plug

S002_En

D3-4-2-2-2a_A_En





  

This product complies with the Low Voltage Directive 2006/95/EC and EMC Directive2004/108/EC.

D3-4-2-1-9a_A_En


 















 

















 


















 










$
"



 
 

!






 



 


"
 $




 


$
$
 
!






 

 
 

 
!



 


$



! 
 
 


$
!


 


"

"


 







#
"


!




$!)
%)./''%)#
/$%.
0)%/
(&!
.0-!
/*
'!1!

.+!
-*0)
/$!
0)%/
"*-
1!)/%'/%*)
/*
%(+-*1!
$!/
- %/%*)
/
'!./

(
/
/*+

(
/
-!-
)

(
/
!$
.% !



'*/.
)
*+!)%)#.
%)
/$!
%)!/
-!
+-*1% !
"*-
1!)/%'/%*)
/*
!).0-!
-!'%'!
*+!-/%*)
*"
/$!
+-* 0/
)
/*
+-*/!/
%/
"-*(
*1!-$!/%)#
*
+-!1!)/
"%-!
$4- 
/$!
*+!)%)#.
.$*0'
)!1!-
!
'*&!
*-
*1!-!
2%/$
%/!(.
.0$
.
)!2.++!-.
/'!'*/$.
0-/%).
*-
3
*+!-/%)#
/$!
!,0%+(!)/
*)
/$%&
-+!/
*-

! 

  )

POWER-CORD CAUTION


!
$

%
!
"

!
"
"!
!
"
%
!"
!


#
!"
!
$

$
%"


$!

!
"
" 

!
"!

!


!

!
"!



"!"
!

!
$



!

#


!

!


!
!
$!
!
 

$

"

"!
"
!!
!%

!
%
!

!



$


" 



#
%"

!


!
$




$

%"

!

 
%"
 !
  
"!&
#
!

%"



!

CAUTION

The
STANDBY/ON switch on this unit will not completely shut off all power from the AC outlet. Since the power cord serves as the main disconnect device for the unit, you will need to unplug it from the AC outlet to shut down all power. Therefore, make sure the unit has been installed so that the power cord can be easily unplugged from the AC outlet in case of an accident. To avoid fire hazard, the power cord should also be unplugged from the AC outlet when left unused for a long period of time (for example, when on vacation).

This product incorporates copyright protection technology that is protected by method claims of certain U.S. patents and other intellectual property rights owned by Macrovision Corporation and other rights owners. Use of this copyright protection technology must be authorized by Macrovision Corporation, and is intended for home and other limited viewing uses only unless otherwise authorized by Macrovision Corporation. Reverse engineering or disassembly is prohibited.

This product includes FontAvenue® fonts licenced by NEC Corporation. FontAvenue is a registered trademark of NEC Corporation.

Replacement and mounting of an AC plug on the power supply cord of this unit should be performed only by qualified service personnel.

IMPORTANT: THE MOULDED PLUG

This appliance is supplied with a moulded three pin mains plug for your safety and convenience. A 5 amp fuse is fitted in this plug. Should the fuse need to be replaced, please ensure that the replacement fuse has a rating of 5 amps and that it is approved by ASTA or BSI to BS1362.

Check for the ASTA mark or the BSI mark on the body of the fuse.

If the plug contains a removable fuse cover, you must ensure that it is refitted when the fuse is replaced. If you lose the fuse cover the plug must not be used until a replacement cover is obtained. A replacement fuse cover can be obtained from your local dealer.

If the fitted moulded plug is unsuitable for your socket outlet, then the fuse shall be removed and the plug cut off and disposed of safely. There is a danger of severe electrical shock if the cut off plug is inserted into any 13 amp socket.

If a new plug is to be fitted, please observe the wiring code as shown below. If in any doubt, please consult a qualified electrician.

IMPORTANT: The wires in this mains lead are coloured in accordance with the following code: Blue : Neutral Brown : Live

As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows ;

The wire which is coloured BLUE must be connected to the terminal which is marked with the letter N or coloured BLACK.

The wire which is coloured BROWN must be connected to the terminal which is marked with the letter L or coloured RED.

How to replace the fuse: Open the fuse compartment with a screwdriver and replace the fuse.

D3-4-2-1-2-2_B_En

3

En