Pioneer DV-464 Before you start What’s in the box, Putting the batteries in the remote control

Before you start

What’s in the box

Please confirm that the following accessories are in the box when you open it.

•Remote control

•AA/R6P dry cell batteries x2

•Audio/video cable (red/white/yellow plugs)

•Power cable

•Operating instructions

•Warranty card

01

1Open the battery compartment cover on the back of the remote control.

2Insert two AA/R6P batteries into the battery compartment following the indi-

cations ( , ) inside the compartment.

Putting the batteries in the remote control

Incorrect use of batteries can result in hazards such as leakage and bursting. Please observe the following:

•Don’t mix new and old batteries together.

•Don’t use different kinds of battery together—although they may look similar, different batteries may have different volt- ages.

•Make sure that the plus and minus ends of each battery match the indications in the battery compartment.

•Remove batteries from equipment that isn’t going to be used for a month or more.

•When disposing of used batteries, please comply with governmental regulations or environmental public instruction’s rules that apply in your country or area.

H048 En

3 Close the cover.

Using the remote control

Keep in mind the following when using the remote control:

•Make sure that there are no obstacles between the remote and the remote sensor on the unit.

•The remote has a range of about 7m.

•Remote operation may become unreliable if strong sunlight or fluorescent light is shining on the unit’s remote sensor.

•Remote controllers for different devices can interfere with each other. Avoid using remotes for other equipment located close to this unit.

7

En