Toshiba SD-KV550SU owner manual NEC Section, S2898A

Page 4

Introduction

IMPORTANT SAFEGUARDS

13.LIGHTNING

To protect your unit from a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable system. This will prevent damage to the unit due to lightning and power line surges.

14.POWER LINES

An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can fall onto or against such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits, as contact with them might be fatal.

15.OVERLOADING

Do not overload wall outlets and extension cords, as this can result in a risk of fire or electric shock.

16.OBJECT AND LIQUID ENTRY

Do not push objects through any openings in this unit, as they may touch dangerous voltage points or short out parts that could result in fire or electric shock. Never spill or spray any type of liquid into the unit.

17.OUTDOOR ANTENNA GROUNDING

If an outside antenna or cable system is connected to the unit, be sure the antenna or cable system is grounded to provide some protection against voltage surges and built-up static charges, Section 810 of the National Electrical Code, ANSI/NFPA 70, provides information with respect to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna discharge unit, connection to grounding electrodes, and requirements for the grounding electrode.

EXAMPLE OF ANTENNA GROUNDING AS PER THE

NATIONAL ELECTRICAL CODE

 

ANTENNA LEAD IN WIRE

GROUND CLAMP

 

 

ANTENNA

 

DISCHARGE UNIT

 

(NEC SECTION 810-20)

ELECTRIC SERVICE

GROUNDING CONDUCTORS

EQUIPMENT

(NEC SECTION 810-21)

 

 

GROUND CLAMPS

 

POWER SERVICE GROUNDING

NEC-NATIONAL ELECTRICAL CODE

ELECTRODE SYSTEM

S2898A

(NEC ART 250, PART H)

 

18.SERVICING

Do not attempt to service this unit yourself as opening or removing covers may expose you to dangerous voltage or other hazards. Refer all servicing to qualified service personnel.

For example:

a.When the power-supply cord or plug is damaged.

b.If liquid has been spilled, or objects have fallen into the unit.

c.If the unit has been exposed to rain or water.

d.If the unit does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operating instructions, as an improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the unit to its normal operation.

e.If the unit has been dropped or the cabinet has been damaged.

f . When the unit exhibits a distinct change in performance, this indicates a need for service.

4

2I30201B-En_p02-13

4

1/13/06, 2:46 PM

Image 4
Contents SD-KV550SU Toshiba CorporationIntroduction Location of the required MarkingS3125A IntroductionNEC Section S2898AHeat DiscPrecautions Do not use the DVD/VCR when moisture condensation may occurWait Moisture condensation occurs during the following casesOn cleaning discs On handling discs Structure of disc contentsOn storing discs Playable discs On Video CDsDVD Contents Front panel Identification of controlsRear panel Display window VCR operation statusDisc operation status While watching TV While operating a tapeRemote control DVD Menu buttonInserting batteries OperationAntenna connections Antenna to DVD/VCR connectionConnections DVD/VCRConnections Set the TV/CABLE menu option to TV mode To the TV modeSet the TV/CABLE menu option to TV mode DVD/VCR to TV connectionCable TV connections ConverterDescrambler Converter/DescramblerSplitter Incoming Cable Converter/Descrambler Switch ConnectionsSplitter Splitter Converter/DescramblerConnecting to a TV Basic connectionProgressive outputs Interlaced outputsConnecting to optional audio equipment Connecting to an amplifier equipped with a DTS decoderEncoded via the MPEG2 Use DVD video discsRecording system Setting the video channel Setting the video channelBasic setup VCR When a TV is connected with the 75 ohm coaxial cable onlySetting the language Setting the languageAuto Clock adjustment Clock settingTo set Auto Clock to off To set Standard Time GMT Greenwich Mean TimeManual clock setting Example Setting the clock to 830 AM March, 25 SATPress SET + or to set the month, then press EnterTuner setting Setting channels automaticallyTV/CABLE selection VCRTo ADD/DELETE channels Noise eliminationTo delete channels + or to select no Noise BackgroundLoading and unloading a cassette tape LoadingUnloading To prevent accidental erasurePlayback Cassette tape playbackRewind or forward the tape Special playback Convenience function Repeat playback Zero return functionDVD mode VCR mode Clock/counter display Video index search systemSqpb S-VHS Quasi Playback Counter ClockRecording a TV program Recording a TV programRecording VCR VHF/UHF/CABLE TV Channels Cable TVTo stop recording temporarily To stop recordingRecording one program while watching another One-touch Timer Recording OTR One-touch Timer Recording OTRTo cancel OTR Set TV or Cable option toTimer recording Timer recordingPress Cancel to move cursor backward for correction Press SET + or to select one of the programTo confirm or cancel a program To confirm Timer programTo cancel Timer program If the programs overlap anotherStereo recording and playback Second Audio Program SAP Other functions VCROutput selection Then press VCR Menu until Menu screen is clearedPress Stop when you finish duplicating Duplicating a video tapeDuplicating a video tape Connection with second VCRRecording a DVD/CD disc Press Stop when you finish recordingDuplicating a DVD or CD disc Vcddvd Basic playback Playing a discBasic playback DVD Play VCD Playing in fast reverse or fast forward directions Vcddvd Playing frame by frameVcddvd Playing in slow-motion VCD Locating a chapter or trackZooming/Locating desired scene VCD ZoomingVCD Locating desired scene Advanced playback DVDDVD Marking the scenes Marking desired scenesVcddvd Returning to the scenes Vcddvd Repeat playback Repeat playback/A-B Repeat playbackVCD A-B Repeat playback Program playback Program playback/Random playbackRandom playback Changing angles/Title selection/DVD menu DVD Changing anglesDVD Title selection DVD DVD menuDVD Setting surround sound Changing soundtrack language Setting surround soundDVD Changing soundtrack language Press Play Mode in the stop mode Subtitles/To turn off the PBCDVD Subtitles To turn off the PBCMP3/WMA/JPEG and Audio CD operation MP3/WMA/JPEG CD informationLimitations on MP3/WMA/JPEG CD playback Limitations on displayCD MP3/WMA CD and Audio CD playback Press Stop to end playbackFile browser screen will appear on ScreenCD Jpeg CD playback CD Slide show playbackSelect Mode Off in step CD Repeat playback CDCD Random playback CD Press PLAY.The Random playback will startCD Program playback CD Browser ViewCustomizing the function settings VCD Setting procedureFunction setup DVD ReturnSetting details Menu, Subtitle, Audio English, Francais, EspanolOriginal Audio Off SubtitlePicture Mode DisplayJpeg Interval OffDRC If you forget the password OutputInterlace ProgressiveTemporary disabling of rating level by DVD disc Load a DVD disc and press Play or OpenClose on the unit Disc is ejectedLanguage code list OthersSymptoms Solutions TroubleshootingOthers Specifications Supplied accessoriesGeneral Input/OutputLimited warranty Limited Ninety 90 Day WarrantyRental Units Commercial UnitsHow to Obtain Warranty Services Memo Memo Others J2I30201B SH 06/02 N