Toshiba D-VR610KU owner manual Hints for Timer Recording, Priority of Overlapped Settings

Page 41

TIMER RECORDING

Introduction

Hints for Timer Recording

•If there is a power failure or this unit has been unplugged for more than 30 seconds, the clock setting and all timer programming will be lost.

•If a disc is not inserted or if a inserted disc is not recordable (finalized DVD-RW/-R, finalized DVD+RW, a fully recorded disc, etc.), “DVD” on the front panel

display flashes and timer recording cannot be performed. In some cases, will appear momentarily around the start point as the unit attempts to record. Please insert a recordable disc.

•If a cassette tape with an erase-protection tab is not in the cassette compartment or there is no cassette tape in the cassette compartment, “VCR” on the front panel display flashes and timer recording cannot be performed. Please insert a recordable cassette tape.

•If you press [TIMER SET] and turn on the unit while either DVD or VCR is in timer standby mode, disappears. In this case, you cannot change the mode between DVD and VCR. You cannot change any settings using [SETUP] or edit discs.

•When all the timer recording is completed, flashes. To play back or eject the recorded disc, press

[I/y ON/STANDBY] first, then select the recorded title and press [PLAY B], or [OPEN/CLOSE A] to remove the disc.

•During timer recording or timer standby mode ( will appear), any operations on the unit will not be available. To make these operations available, press [C STOP] on

the front panel to cancel the timer recording or [TIMER SET] to release timer standby mode ( will disappear).

•To cancel the timer standby mode, press [TIMER SET].

•When the starting and the ending time are the same, “Exceeds 12 hours” appears and the program setting will not be accepted.

•When the programmed starting and ending time are earlier than the current time, the setting will not be accepted.

•If the starting time is earlier and the ending time is later than the current time, the recording will start right after you turn the power off.

•The timer recording cannot be performed in DVD and VCR at the same time. If you set 2 programming with the same channel and time in both devices, the program with a lower program number will be recorded.

Disc Connections Basic Setup Management

The Priority of Overlapped Settings

This unit records the programs according to priority if the timer programmings are overlapped. The timer programming set previously has priority.

A timer recording of lower priority will be canceled or start from the middle. Check the overlapped timer programmings and change the priority if necessary.

When the starting time is the same:

 

When the starting time and the ending time

A program set previously (PROG. A) has priority.

 

for each programs are different:

 

 

A program that has earlier start time has priority.

Recording

PROG. A

 

 

 

 

 

 

PROG. A

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

PROG. B

 

 

 

 

 

 

PROG. B

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

PROG. C

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

actual

 

 

 

 

 

 

actual

 

 

 

 

 

 

 

 

 

PROG.A.A

 

 

PROG. B

 

 

PROG. A

 

 

PROG. C

 

PROG.B

 

recording

 

 

 

 

recording

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

cut off.

 

The first 2 minutes (at the longest) will be

cut off.

 

 

 

The first 2 minutes (at the longest) will be

 

 

Playback

When the recording time is partially overlapped:

PROG. A will start after PROG. B is complete to be recorded.

PROG. A

PROG. B

 

 

 

 

 

actual

 

 

 

 

 

 

PROG.B

 

 

PROG.A

recording

 

 

 

 

 

 

 

 

The first 2 minutes (at the longest) will be

cut off.

When the recording time is entirely overlapped:

PROG.A will not be recorded.

PROG. A

 

PROG. B

 

actual

PROG. B

recording

 

Editing Function Setup

Note for DVD recording

•When the recording time of 2 programs are overlapped, or the end time of a program and the start time of another program is the same, the first 2 minutes (at the longest) of the subsequent program will be cut off.

•If the cut-off portion comes up to 3 minutes or more, this program will be displayed with errors number E40 in the timer programming list.

When the end time of the programming currently being recorded and the start time of the subsequent program are same:

The beginning of the PROG. B may be cut off.

PROG. A

 

 

PROG. B

 

 

actual

PROG. A

PROG. B

recording

 

 

The first 2 minutes (at the longest) will be cut off.

EN

41

VCR Function Others

E9KGAUD_D-VR610KU_EN.indd 41

2007/12/18 17:10:15

Page 40 Page 42
Image 41
Page 40 Page 42
Contents Editing Owner’s RecordLaser Safety PrecautionsMake your contribution to the environment RADIO-TV InterferencePrecautions Important Safety InstructionsSupplied Accessories Installation LocationAvoid the Hazards of Electrical Shock and Fire Moisture Condensation WarningCleaning the Cabinet Maintenance ServicingCleaning Discs Cleaning the Disc Lens Disc HandlingContents Contents Features DVD-RW DVD+RW FeaturesColor Systems Unplayable DiscsRegion Codes CD-DA CD-RWFront Panel Functional OverviewRear Panel Introduction ConnectionsUsing a Remote Control Installing the Batteries in the Remote ControlFunctional Overview Open the cover Insert batteriesVCR mode OPEN/CLOSE a button DVD modeSetup button Clear button DVD modeVCR mode Thevcr / DVD Recorder SwitchingOFF On-Screen Display / MenuTitle name information Guide to ON-SCREEN Displays and MenusFile name information First, track name will be displayedMain Menu DB HDD Front Panel Display GuideDisplay Message Following the steps in Settings for the Video Input Plug in the power cords of the devices to the AC outletWith this setup Make the connection as illustrated belowIf you want to use S-VIDEO in jack, select S-Video Settings for the Video InputPress Setup to exit This unit Connection to a TVAudio OUT DVD Video OUT Component Video OutputAvailable for DVD only Hdmi Mode and Actual Output SignalsHdmi cable Cables not included2channel PCM Actual Output Modes by MediaDVD-video Stream Dolby Digital DivX Stream Dolby Digital MP3 / MP2Audio Connection to AN Audio SystemAudio OUT Digital Audio OUTPress Enter to activate Clock Initial SettingProceed to in Clock Setting on Clock Setting Setting the ClockSet the clock before you try the timer programming Use K / L to select calendar or time, then press EnterChoosing the Recording Format of a Brand-New DVD-RW Formatting a DiscUse K / L to select Format, then press Enter Use K / L to select Format Mode, then press EnterFormatting a Disc If you want to cancel formatting, select NoReformatting a Disc Manually Formatting is completed.100% is indicatedPress Setup Use K / L to select DVD Menu, then press Enter Setting a Disc to ProtectTo cancel the disc protect Use K / L to select Disc ProtectAuto Finalizing General Setting menu will appearYour setting will be activated Finalizing is completed Playing the Discs in Other DVD PlayersFinalizing a Disc 32 EN Information on DVD Recording Recording ModeRestrictions on Recording VideoSetting for Auto Chapter Settings for a RecordingPress Setup to exit Make Recording CompatibleSetting Aspect Ratio for Video Mode Settings for a RecordingRecording Audio Select XP RecordingPress I/y ON/STANDBY Press REC Mode to select a recording modePress OPEN/CLOSE a to close the disc tray It may take awhile to load Disc completelyWill be displayed for 5 seconds Press REC I to start recordingPress Stop C to stop recording Guide to Timer Programming Display Timer RecordingBefore recording, make sure If you have not set the clock yetPress Enter when all items are entered Timer RecordingPress Timer SET to set a timer programming Use K / L to enter the date, then press BTo stop the timer recording in progress Recording Hints for Timer RecordingPriority of Overlapped Settings Preparation on this unit Use K / L to select the recording modeSatellite Link Press Timer SET to turn on the unit To Standby Mode is highlightedSatellite Link Press EnterConnection to an External Device External deviceRecording from an External Device Settings for AN External DeviceGuide to DV and On-Screen Display DV DubbingDVC to DVD Dubbing DV DubbingPress DVD first Press DisplayPress VCR first DVC to VCR DubbingRepeat the steps 1 and 2 on To stop recording, press Stop CUse K / L to select Dubbing Mode, then press Enter DVD/VCR DubbingUse K / L to select Recording, then press Enter Make surePress DVD DVD/VCR DubbingPress Dubbing Press Stop C to stop the recordingInformation on Playback Structure of Disc ContentsPress Stop C once to stop playback temporarily Basic PlaybackDirect Playback Use K / L / / B to select a desired title, then press Enter Basic PlaybackPlayback from the Title List When selecting folder When selecting track/fileHints for audio CD tracks and MP3 / WMA / Jpeg files MP3 / WMAFollow steps 1 to 2 in Direct Playback on When selecting filePlaying Back a DivX DivX3.x, DivX4.x Official DivX Certified productDivX5.x, DivX6.0 Maximum size of imagePause Using the Title/Disc MenuPress DVD first During playback, press Pause F Playback will be paused and sound will be mutedResume Playback Special PlaybackFast Forward / Fast Reverse Playback 40x REVRapid Playback Special PlaybackStep by Step Playback Slow Forward / Slow Reverse PlaybackPress DVD first During playback, press Display or Zoom Marker SettingZoom During recording, press Play B Chasing Playback during RecordingWhile viewing a TV broadcast via this unit, press Time Slip This unit start to record the TV broadcastSelected title playback will start Simultaneous Playback and RecordingChapter To move to for chapter, press BUsing Display Using Skip j / SkipSearch Title/Chapter SearchTime Search SearchRandom Playback Repeat PlaybackProgram Playback REPEAT/RANDOM/PROGRAM PLAYBACK/SLIDE ShowSlide Show 5Press Play BSwitching Audio Soundtrack Switching SubtitlesReducing Block Noise Switching Virtual Surround System Switching Camera AnglesSelecting the Format of Audio and Video Use K / L to select Black Level, then press Enter Adjusting Black LevelGuide to a Title List Information on Disc EditingAfter the disc is fully recorded Deleting TitlesDeleting Titles Adding Titles to a Playlist CREATING/DELETING PlaylistUse K / L to select Yes, then press Title is added to playlistErasing All Playlist CREATING/DELETING PlaylistUse K / L to select Yes, then press ENTER.DVD Menu Playlist can be deleted if it is no longer neededPutting Names on Titles Editing DiscsGuide to Edit Title Name Editing DiscsPutting Names on Titles cont’d Use Skip H / G Setting Chapter MarksPress Return Press Return again and then Return or Stop C to exitUse K / L to select Edit, then Hiding ChaptersUse Skip H or Skip G to decide the chapter to be hidden Use K / L to select Hidden, thenDeleting a Part of a Title VR mode DVD-RW playlistPress Return and then Return or Stop C to exit Deleting a Part of a Title cont’dUse K / L to select Delete then press Enter Use K / L/s / B to select a desired title, then press Enter Dividing a TitlePress DVD Stop mode, press TOP Menu Two titles will combine into a single title Combining TitlesYou can combine two titles into a single title To protect a whole disc VR mode DVD-RW, DVD+RW/+R only Setting or Releasing the Title ProtectionConfirm the indication OFF ON. Press Enter again Use K / L to select Protect, thenThen press Enter Setting or Clearing All Chapter Marks at OnceUse K / L to select Chapter Mark Use K / L to select the desired interval, then press EnterSetup Items highlight is the default Contents List of the Default SettingsItems highlight is the default Contents List of the Default SettingsPlayback General SettingUse K / L to select a desired item Then press EnterParental Lock Default OFF General SettingUse the Number buttons to enter the current password Playback cont’dAudio Out Audio Language Default Original Disc Menu Language Default EnglishSubtitle Language Default OFF Angle Icon Default onScreen Saver Default 10 minutes OSD Language Default EnglishFL Dimmer Default Bright DisplayDisplay cont’d Use the Number buttons to enter the access passwordChip Use K / L to select a desired item, then press EnterCanadian English Rating Use the Number Buttons to enter new access passwordTV Aspect Default 43 Letter Box Progressive Default OFFVideo Selected itemDivX DivX Subtitle Default OFFDivX VOD Set the DivX subtitleUse K / L to select HDMI, then press Enter Format Default RGBSet to OFF when the Hdmi sound is not output Hdmi Audio Default onRGB Range Default Normal Hdmi cont’dReset the setting to default Reset AllSelect Yes using K / L , then press Enter Tracking VCR FunctionsPress VCR first Before recording, make sure Recording speedYou cannot pause the one-touch timer recording One-touch Timer Recording OTRUsing REC I or Stop C VCR FunctionsOther Operations Symptom Remedy TroubleshootingTroubleshooting REC There is no picture Picture noise appearsCan I record to CD-RW/-R? No, this unit records only DVD Frequently Asked QuestionsLanguage Code Language CodeGlossary Input / Output SpecificationsGeneral Limited Warranty Limited WarrantyLPLWHG2QH  HDUDUUDQW\RQ3DUWVDQG/DERXU Limited Warranty$UELWUDWLRQDQGLVSXWH5HVROXWLRQ General Setting 98 EN VCR Functions VCR Functions Time Search Troubleshooting Troubleshooting 104 EN Frequently Asked Questions Language Code Glossary Specifications Limited Warranty Limited Warranty $UELWUDWLRQDQGLVSXWH5HVROXWLRQ
Related manuals
Manual 117 pages 19.72 Kb
Top Page Image Contents