If you forget the password...
1)Press OPEN/CLOSE to open the disc tray.
2)Remove the disc.
3)Press OPEN/CLOSE again to close the disc tray. “No Disc” appears on the screen.
4)While holding 7 down on the remote control and then press STOP on the front panel. “Password Clear” appears on the screen. Now the password has been returned to the initial value (“0000”).
Output
You can select the video output signal of the DVD video player to the TV from “Interlace” or “Progres- sive”.
Interlace:
Select when connecting to a composite TV or a TV equipped with component video inputs but progressive scan is not compatible.
Progressive:
Select when connecting to a TV equipped with component video inputs, progressive scan compatible.
Warning:
Once “Progressive” is selected when connecting to a TV progressive scan incompatible, no image will be seen on the video display.
In this case, you must reset the unit by pressing STOP on the front panel for five seconds. The video output will be restored to “Interlace” setting, and a picture will once again be seen on a conventional analog display.
Notes:
•Some discs may not be played back with the progressive scanning mode correctly because of the disc characteris- tics or recording condition.
•Once Progressive scan on,
DivX® VOD
In order to play DivX® VOD (Video On Demand) content on this unit, you first need to register the unit with your DivX® VOD content provider. You do this by generating a DivX® VOD registration code, which you submit to your provider.
Press C or D to select “DivX(R) VOD”. Then press ENTER. Your
Function setup (DVD)
Note:
If each setup (pages 
~ 63 ) has been completed, the unit can always be worked under the same conditions (espe- cially with DVD discs).
Each setup will be retained in the memory even if you turn the power off.
63
63 | 1/12/06, 17:07 |