Bose GSX Series III manual Setting the remote for your TV

English

DeutschEspañol FrançaisItliano Nederlands Svenska

SETUP

Setting the remote for your TV

To use the 3•2•1® remote with your TV, you must set the remote for the proper TV device code.

1.Refer to the list of “Device codes” on page A-1.

2.In the list for TVs, find the brand of your TV.

3.Write down several codes for your brand so you can try more than one, if needed.

Note: If one code works to turn your TV on and off but does not change channels, you can try other codes to find one that provides more complete TV control.

4.Turn on the TV and your 3•2•1 system.

5.On the 3•2•1 remote, press and hold the TV button for several seconds.

Wait until the red light at the top of the remote turns on.

6. Use the number buttons on this remote to enter the device code for your TV.

The light turns off briefly as you press each key.

7.Make sure the light turns off completely after all digits are entered.

If the light blinks now, the code is invalid. Return to step 5 and try a different code for your TV.

8.Point the 3•2•1 remote at your TV

and press the TV On/Off button.

Use the 3•2•1 remote to turn the TV

on again and change channels, using the number buttons or by pressing Channel up or down.

If it performs both operations, this code is correct. Write the code numbers below:

If this code does not work, repeat steps 5-8 using a different code for your TV.

Note: For a CD changer or combination CD/DVD player and changer, your brand may not be listed in the CD/DVD device codes on page A-21. In some cases, the same brand of DVD or VCR device codes can work with

a changer.

31