Philco PVD2000 manual Copying a Video Tape, Connect

VCR Functions

Copying a Video Tape

Warning: Unauthorized recordings of copyrighted video tapes may be an infringement of copyright laws.

(Back of TV)

(Back of another source) (Back of DVD/VCR*)

	DVD/VCR	VCR			DVD		DVD/VCR	VCR		2
	AUDIO OUT		ANT-IN	DIGITAL		VIDEO OUT
	AUDIO OUT				AUDIOS-VIDEO		AUDIO OUT
or		AUDIO IN	1 AUDIO OUT			COMPONENT		AUDIO IN		Connect
	L				OUTOUT	Y	L		ANT-IN
	R		Connect		L
	VIDEO OUT	VIDEO IN				CB	R
			ANT-OUT	COAXIAL
	VIDEO OUT				R		VIDEO OUT	VIDEO IN	ANT-OUT

CR

				RF cable
				(supplied)
		Audio/Video cables
				*Front input jacks are also available
		(commercially available)
1)	Insert a pre-recorded tape into another VCR for playing.		7) To stop recording, press [STOP/EJECT C A] on the
2)	Insert a tape with its record tab into this unit for recording.			recording unit, then stop playback of the tape in another
3)	Press [SPEED] on the remote control of the recording			source.
4)	unit to select the desired recording speed (SP/SLP).		Hint
	Select the “L1” or “L2” position on the recording unit.		• For best results during dubbing, use the front panel controls
	• To use the input jacks on the back of this unit, select
				whenever possible. The remote control might affect another
	“L1” position by pressing [0], [0], [1] on the remote			source’s operation.
	control or [CHANNEL K/L] on this unit.		• Always use video-quality shielded cables with RCA-type
	• To use the input jacks on the front of this unit, select			connectors. Standard audio cables are not recommended.
	“L2” position by pressing [0], [0], [2] on the remote		• You can use a video disc player, satellite receiver or other audio/
	control or [CHANNEL K/L] on this unit.			video component with Audio / Video outputs.
5)	Press [RECORD] on the recording unit.		• “L1” or “L2” is found before the lowest memorized channel.
6)	Begin playback of the tape in another source.			(Example: CH02)
			• “L2” input jacks are on the front of this unit.

– 14 – EN