Programming the commands of remote controllers for other devices into the remote controller
SEND/LEARN indicator
MODE buttons
ENTER
SEND/LEARN indicator
MODE buttons
ENTER
Erasing the programmed command from one button
You can only erase memorized commands and not preset ones.
1.Press and hold down the MODE button for the command, press the ENTER button, and then release both buttons.
When you press the MODE button, the SEND/LEARN indicator lights. When you press the ENTER button, the lamp turns off. When you release the buttons, the lamp lights again.
2.Press and release the button for the command you wish to erase.
When you press the button, the SEND/LEARN indicator turns off. When you release the button, the lamp lights again.
3.Press and release the same button again.
The SEND/LEARN lamp slowly flashes twice. The memorized command is erased.
Note:
If the SEND/LEARN indicator quickly flashes three times and turns off, then the remote controller has exited the erasing mode because either you have made a mistake during erasing or a
Erasing all the commands programmed under a MODE button
1.Press and hold down the desired MODE button, press the ENTER button twice, and then release both buttons.
When you press the MODE button, the SEND/LEARN indicator lights. When you press the ENTER button, the lamp turns off. When you release the buttons, the lamp slowly flashes twice and then lights again.
2.Press and release the same MODE button again.
When you release the button, the SEND/LEARN indicator slowly flashes twice. This erases all the commands memorized to the MODE button.
Notes:
•If the SEND/LEARN indicator quickly flashes three times and turns off, then the remote controller has exited the erasing mode because either you have made a mistake during erasing or a time- out has occurred because no button has been pressed. Resume from Step 1.
•If many commands have been programmed to the MODE button, then the SEND/LEARN indicator may remain lit for up to 20 seconds during Step 2. This is not a malfunction.
72