Onkyo RC-391M manual Controlling the TX-DS575

Page 1

Using the remote controller

Overview

When you use a remote controller, typically you press one of the MODE buttons that corresponds to the device you wish to control, then press the operation buttons. For example, if you wish to control the TX-DS575 from a remote controller, ﬁrst press the MODE AUDIO but- ton, then press an appropriate operation button. To control a CD player, press the MODE CD button, then press an appropriate operation but- ton.

First, press the desired MODE button to make sure that the TX-DS575 is set to a correct mode.

SEND indicator

POWER ON POWER STNBY

MODE AUDIO

Using the RC-391M to control each device

Turning the power on and off to the TX-DS575

Note:

Before operating the RC-391M, turn on the POWER switch on the TX-DS575 so that the unit enters standby mode.

1.Press the MODE AUDIO button.

2.Pressing the POWER ON buttons will switch between power on. Pressing the POWER STNBY button will power standby.

SEND indicator

This indicator acts as a guide when commands are programmed into or sent by the remote controller. It also warns the user when an error is made or battery power is low.

	POWER ON
	SLEEP	POWER
	SLEEP	STNBY
		STNBY

MODE

AUDIO

DISPLAY

CH +/–

VOL

TEST

MUTING

INPUT

SELECTOR

Litening mode

SP A/B LEVEL +/–

DIMMER

CH SEL

Controlling the TX-DS575

1.Press the MODE AUDIO button.

2.Press the desired operation button.

Shaded buttons in the ﬁgure are the operation buttons used to control the TX-DS575.

SLEEP : Sleep function

POWER ON/STNBY

:Power on/standby

DISPLAY : Changing the display

VOL q/u : Adjusting the volume

CH +/– : Tuner preset number increment/decrement

INPUT SELECTOR

Listening mode (STEREO/DSP√/DSP®/SURROUND)

:Changing Listening mode

SP A/SP B : Switching between Speakers A and B

CH SEL	: Selecting a speaker
DIMMER	: Adjusting the brightness of the display
LEVEL +/–	: Adjusting the speaker levels
TEST	: Test tone
MUTING	: Muting

31

Image 1

Contents Controlling the TX-DS575 Controlling an Onkyo DVD player Controlling an Onkyo CD playerDVD player on-screen button DVD player buttonsControlling an Onkyo MD recorder Mode SAT, CABLE, VCR, and TV buttonsControlling an Onkyo tape deck Repeat Steps 3-4 to program other buttons in the same Mode Programming procedurePress and release the same Mode button again Erasing a learned code from a Mode buttonErasing a learned code Press and release the same button againProgramming Macro mode What is a Macro function?Press the Macro Mode button to complete program- ming TipMacro Direct Learning function Using a Macro functionPress the Macro Direct button again Press the ENT button Erasing all codes and operations programmed in the buttons