Onkyo RC-391M Erasing all codes and operations programmed in the buttons, Press the ENT button

Page 9

Using a Macro function

2

3

Erasing all codes and operations programmed in the buttons

This procedure will erase all remote controller codes for the other devices and all macro operations that have been programmed in the RC-391M (see pages 34, 36 and 37).

1.Open the battery cover and remove the batteries.

2.While pressing and holding down the POWER ON button and the POWER STNBY button, insert the batteries in the correct direction.

After inserting the batteries, release the buttons. The SEND/ LEARN indicator flashes slowly.

3.Press the ENT button.

The SEND/LEARN indicator lights up for about ten seconds, then turns off. All programmed codes are erased and the button memories return to the factory presets.

Note:

•Proceed to Step 3 immediately after Step 2. Otherwise, the bat- teries will be consumed quickly.

•If you press any button other than the ENT button in Step 3, no codes will be erased. In this case, repeat the steps from the beginning.

39

Page 8 Page 9
Image 9
Page 8 Page 9
Contents Controlling the TX-DS575 Controlling an Onkyo DVD player Controlling an Onkyo CD playerDVD player on-screen button DVD player buttonsMode SAT, CABLE, VCR, and TV buttons Controlling an Onkyo MD recorderControlling an Onkyo tape deck Repeat Steps 3-4 to program other buttons in the same Mode Programming procedurePress and release the same Mode button again Erasing a learned code from a Mode buttonErasing a learned code Press and release the same button againProgramming Macro mode What is a Macro function?Press the Macro Mode button to complete program- ming TipMacro Direct Learning function Using a Macro functionPress the Macro Direct button again Press the ENT button Erasing all codes and operations programmed in the buttons
Top Page Image Contents