Using a Macro function
What is a Macro function?
A Macro function enables you to program a series of button operations on the remote controller into a single button. For example, you need to follow the steps below to play a CD player connected to the
1:Press the MODE AUDIO button. → 2: Press the POWER ON button. → 3: Press the CD (INPUT SELECTOR) button. → 4: Press the MODE CD button. → 5: Use the numeric keys to select the desired song.
This operation will be two button presses away if you program these steps into a macro button.
2
1, 2 
1, 3 2 
2
2
Tip:
The codes programmed into a MACRO button will be transmitted with an interval of 0.5 seconds. However, some devices may not be able to complete one opera- tion in 0.5 seconds and may miss the next code. In this case, press one operation button, press the correspond- ing MODE button, then press another operation button to extend the interval between the two operations up to one second.
Programming Macro mode
You may program the desired steps into each of eight MODE but- tons. The following example explains how to program Steps
1.Press and hold down the desired MODE button you wish to program (in this case, MODE CD button), and press the MACRO MODE button. Then release the buttons.
When you press the MODE CD button, the SEND/LEARN indicator lights up. When you press the MACRO MODE button, the indicator turns off.
When you release the buttons, the indicator flashes briefly, then lights up again.
2.Press the operation buttons in series you wish to program into the MACRO MODE button.
Press the MODE AUDIO, POWER ON, CD (INPUT SELEC- TOR), MODE CD buttons, and a numeric key. When you press the button, the SEND/LEARN indicator turns off. When you release the button, the indicator lights up.
3.Press the MACRO MODE button to complete program- ming.
The SEND/LEARN indicator flashes twice slowly.
Repeat Steps
4.Check to see if the series of button operation has been cor- rectly learned.
Point the remote controller toward the
Transmitting the codes in Macro mode takes a while. During transmission, point the remote controller toward the device to be controlled.
Note:
•You may program up to 16 button operations into each MACRO button. If you try to program the 17th step, it will be ignored.
•If you do not press any button for more than 30 seconds during the procedure, the SEND/LEARN indicator flashes three times quickly, then the
•If you make a mistake during programming, the SEND/LEARN indicator flashes three times quickly, then the
•If you erase one of the operation buttons already programmed in the MACRO MODE button, or if you program a different code into such a button, the operation button will no longer work. In this case, program the buttons again to avoid malfunction.
36