Troubleshooting, Problem Solution | Onkyo DV-BD507 manual

TROUBLESHOOTING

If the unit does not perform properly when operated as instructed in this manual, check the unit, consulting the following checklist.

Problem

Solution

No power	-	Check if the AC cord is properly connected.
	- Unplug the AC cord once, and wait for 5-10 seconds and then plug it in again.
No sound or picture	-	Check if the connected TV is turned on.
	- Check if the connections are made securely and correctly.
	- Check whether the connected TV or other device supports HDCP. (This unit will
		not output a video signal unless the other device supports HDCP.)
	- Check whether the output format of this unit (HDMI FORMAT) matches the
		supported input format of other connected device.
	- When this unit is connected to the DVI jack on your TV or AV receiver, you
		cannot hear any sound from the HDMI OUT if your TV or AV receiver only
		supports DVI.
Distorted picture	-	Sometimes a small amount of picture distortion may appear.
		This is not a malfunction.
	- Connect this unit directly to the TV. If the RCA audio / video cables are
		connected to a VCR, pictures may be distorted due to the copy right protection
		system.
Completely distorted picture or	-	Make sure the disc is compatible with this unit.
black / white picture with BD / DVD
No sound or distorted sound	-	Adjust the volume.
	- Check that the speakers are connected correctly.
	- Check the HDMI connections.
	- Check the settings in “Audio” menu.

Picture freezes momentarily	-	Check the disc for fingerprints / scratches and clean with a soft cloth wiping
during playback		from center to edge.
	-	Clean the disc.
Disc cannot be played back	-	Clean the disc.
	- Ensure the disc label is facing up.
	- Check if the disc is defective by trying another disc.
	- Cancel the ratings control or change the control level.
	- Insert a correct disc that can be played back on this unit.

SD Memory Card cannot be read. - The format of the card does not match to this unit or the card is not compatible.

No return to start-up screen when disc is removed

- Reset this unit by turning it off, then on again.

The unit does not respond to the remote control

-Aim the remote control directly at infrared sensor window on the front panel.

-Reduce the distance to infrared sensor window.

-Replace the batteries in the remote control.

- Re-insert the batteries with their polarities (+ / - signs) as indicated.

- Check if a strong light source is not interfering with this unit's infrared sensor.

	Make sure that the unit is not subjected to direct sunshine or inverter-type
	fluorescent lights. Relocate if necessary.
	- If the BD player is installed in a cabinet with colored glass doors, the remote
	control may not work reliably when the doors are closed. Open the doors, or use
	a cabinet without colored glass.
Buttons do not work or the unit	- To completely reset the unit, unplug the AC cord from the AC outlet for 5-10
stops responding	seconds.
The unit does not respond to	- Operations may not be permitted by the disc.
some operating commands	Refer to the instructions of the disc.
during playback
The unit cannot read BD / DVD /	- Condensation? (Let sit 1 or 2 hours)
CD	- You are attempting to playback a disc other than one with one of the marks on
	page 19.
	- Wipe the dirt off the disc or replace the disc.
Angle does not switch	- The angle cannot be switched for BD / DVD which do not contain multiple
	angles. In some cases multiple angles are only recorded for specific scenes.
Playback does not start when	- Check the settings in “Parental” menu.
the title is selected