Onkyo Connecting -compatible Components, Hdmi & the DV-CP704, Video, Audio Formats

Connecting the DV-CP704—Continued

Notes:

•The DV-CP704 supports HDCP (High-bandwidth Digital Content Protection), a protection system for digital video. HDMI components that you connect to the DV-CP704 must also support HDCP.

•The DV-CP704 supports High-Definition Multimedia Interface Specification Information Version 1.0.

HDMI & the DV-CP704

■Video

The DV-CP704’s HDMI OUT supports the following video resolutions:

•720 x 480p 60 Hz

•720 x 576p 50 Hz (Australian model only)

•1280 x 720p 50/60 Hz

•1920 x 1080i 50/60 Hz

If the connected HDTV or projector doesn’t support a resolution, you may get no picture.

On the DV-CP704, you can select a resolution suitable for use with the connected HDTV or projector (see page 39).

■Audio Formats

The DV-CP704’s HDMI OUT supports the following audio formats:

•PCM (48 kHz, 44.1 kHz, 96kHz)

•Dolby Digital

•DTS

If your TV only supports HDMI digital audio up to

48 kHz, change the Linear PCM Out setting to Down Sample On (see page 45).

If your TV doesn’t support Dolby Digital, set the Digital/ HDMI Audio Out setting to PCM (see page 45).

If your TV doesn’t support DTS, the DV-CP704 will not be able to play DTS format audio or soundtracks. In this case, on your DVD-Video disc’s audio setup menu, select an audio format other than DTS.

Connecting -compatible

Components

AV receiver

IN

L

REMOTE

CONTROL

R

•The remote controller supplied with Onkyo AV receiver or amplifiers can be used to control the DV-CP704.

•The function of the upper and lower connectors are the same. Connect to either one.

•Connecting an cable only does not make the sys- tem operational. You must also connect the audio cables as well.

•For remote control operation, you must make an ana- log RCA connection between your DV-CP704 and the other AV component, even if they are connected digi- tally.

21