Onkyo DPS-5.5 Using the Remote controller with Other Brand’s TVs, Learning a pre-programming code

Using the Remote controller with Other Brand’s TVs

Learning a pre-programming code

	On	Standby	Open/
			Close
		Repeat A-B Random
			Play Mode
	1	2	3
Numbers			Display
	4	5	6
			Dimmer
	7	8	9

0Clear

Top MenuMenu

///

Enter

	Return		Setup	Enter
	Audio	Angle Subtitle	Zoom
	Stop	Play	Pause
		Down	Up
		T V Control
On/		TV/Video Channel
	On/			TV Control
	Standby Volume

Standby

RC-536DV

You can make RC-536DV remote controller to operate a TV from other brand than Integra by storing the pre-pro- gramming code of the brand in the RC-536DV.

5	Press some operation buttons
	for the component that you want
	to operate to check if the system
	operates properly.
	If the system operates properly, the
	code is correct. If the component does
	not operate properly, return to step 2.

Notes:

•With some brand’s components, some buttons may not work correctly.

•If more than one code is given in the table, try the code one by one until you reach the code for your compo- nent (i.e. if the first code does not work, then try the next).

•The code can be retained by changing the batteries within 1 minute. If the code is lost, store the pre-pro- gramming code again.

Controlling a TV

1	On/	Press On/Standby to turn on the
	Standby	device.

1	Find the 3-digit number for the
	brand name of the component
	that you want to operate in the
	table on page 55.
2	Turn on the TV that you want to
	operate.

2

Channel

Volume

Press the desired operation but- ton.

+: Changes the TV channel upward.

–: Changes the TV channel down- ward.

3 On/ Standby

Enter

While holding down the On/ Standby on the RC-536DV that you want to program, press Enter, and then release both but- tons.

(Make sure you press On/Standby before Enter.)

TV/Video

: Increases the TV volume.

:Decrease the TV volume. TV/Video : Switches the TV/VCR

inputs.

4		Within 10 seconds, enter the 3-
		digit code number.
1	2	3
4	5	6
7	8	9
	0

54