Index to Parts and Controls, Front panel

Index to Parts and Controls

For operational instructions, refer to the page indicated in brackets.

■Front panel

4 5







8	9	0- = ~ !@ # $	^ & * (
		%

1(European and some Asian models only) POWER switch [26]

Turns on the main power supply for the DVD Receiver. The DVD Receiver enters standby state. Pressing the switch again to the off position (— OFF) shuts down the main power supply into the DVD Receiver.

Before turning on the power, make sure all cables are properly connected.

2STANDBY/ON button, STANDBY indicator [26, 37]

When STANDBY/ON button is pressed to ON (while the POWER switch is set to ON on the European and some Asian models), the DVD Receiver turns on. The STANDBY indicator turns off and the display lights up. Pressing the button again returns the DVD Receiver to the standby state. This state turns off the display, disables control functions.

3Disc tray [34]

When loading a disc, place discs in the disc tray with the label side facing up.

4 0 button [34, 37]

Press to open and close the disc tray.

5DISPLAY button [62, 63]

Press to change the information being displayed.

6FM MODE button [38]

Press to switch the reception mode between stereo and monaural.

7MASTER VOLUME control [42]

The MASTER VOLUME dial is used to control the volume level.

8PHONES jack [42]

This is a standard stereo jack for connecting stereo headphones.

9Display [11]

0INPUT 5/∞ buttons [38, 39, 40]

Press to select the input source.

-7 button [37]

Press to stop playback. Pressing once enables playback to resume from a point shortly before the location where it was stopped. Pressing twice causes the disc to return to the beginning of the disc when playback starts again.

=£ button [34, 37]

Press to start or resume playback.

~TUNING/PRESET 4/¢ buttons [36, 38, 39]

Press to go back or advance to previous chapters/tracks. Also, use these buttons to change the tuner frequency.

!PRESET MEMORY button [38, 39]

Press to assign the radio station that is currently tuned in to a preset channel or delete a previously preset station.

@Front panel illumination

#SURROUND button [48]

Press to select a surround mode.

$STEREO button [48]

Press to change the listening mode to “Stereo”.

%T-D button, indicator [47]

Press to activate Theater-Dimensional mode. T-D indicator illuminates in Theater-Dimentional mode. T-D indicator goes off when other mode is selected.

^ACOUSTIC CONTROL button [50]

Press to change the acoustic mode to boost the super bass/high frequency sounds.

&Remote control sensor [15]

Point the remote control toward the remote sensor to operate the DVD Receiver.

*SUBWOOFER MODE button [31]

Press to select the subwoofer mode.

((North American and South American model) SPEAKER A/B button [29, 42]

Press to switch the speaker systems in use between A and B.

(Other models)

SPEAKER SETUP button [30]

Press to select the optimum speaker configuration.