Onkyo DR-S2.2 Troubleshooting, Amplifier Symptoms Causes Remedies Pages, CD/Audio CD

Page 84

Troubleshooting

Check the following guide for the possible cause of a problem before contacting service. Refer also to the respective instruction manuals of the connected components and TV.

Amplifier

Symptoms

Causes

Remedies

Pages

The DVD Receiver doesn’t

The power cord (mains lead) is

Check the connection of the power cord

26

switch on.

 

disconnected.

 

(mains lead).

 

 

The main power is set to OFF.

Turn on the main power.

26

 

There is external noise interfering with the

Switch off the main power, then switch it on

26

 

 

computer circuits of the DVD Receiver.

 

again. If not recovered, disconnect the power

 

 

 

 

 

cord (mains lead), then connect it again.

 

 

• The AC fuse is blown.

• Contact your nearest Onkyo service

 

 

 

 

center.

 

No sound is reproduced.

The muting function is activated.

Deactivate the muting function.

42

 

The DVD Receiver is not properly

Check the connections to the DVD

16-25

 

 

connected.

 

Receiver.

 

 

• The amplifier protection circuitry has

• Contact your nearest Onkyo service

 

 

activated. (The STANDBY indicator

 

center.

 

 

 

flashes.)

 

 

 

 

Headphones are connected.

Decrease the volume, then disconnect the

43

 

 

 

 

headphones.

 

No sound or very little

The speakers are not properly connected.

Check the speaker connections.

18, 19

sound is reproduced from

The listening mode is set to “Stereo” or

No sound is reproduced from the center

44, 48

the center speaker.

 

“Orchestra.”

 

speaker when the listening mode is

 

 

 

 

 

“Stereo” or “Orchestra.”

 

 

The volume level of the center speaker

Adjust the volume level of the center

33

 

 

(“Center”) is set to minimum.

 

speaker.

 

 

A speaker configuration without the center

Check that the selected speaker

29, 30

 

 

speaker is selected.

 

configuration includes the center speaker.

 

No picture appears on the

• The TV is not set to receive the output

• Set the TV to the DVD Receiver’s input.

TV screen.

 

signals from the DVD Receiver.

 

Refer to the instruction manual of TV.

 

 

The video connection cable is not

Check the connections between the DVD

16, 17

 

 

connected securely.

 

Receiver and TV set.

 

 

Only the S video connection is made.

Also make video connection.

16, 17

 

 

 

 

 

 

The sound of the playback

Another input source is selected.

Select the appropriate input source.

40

source is not heard.

 

 

 

 

 

 

 

 

 

 

 

The buttons on the remote

Power supply fluctuations or other

Switch off the main power, then switch it on

26

controller and DVD

 

abnormalities such as static electricity

 

again. If not recovered, disconnect the power

 

Receiver do not operate.

 

may interrupt correct operation.

 

cord (mains lead), then connect it again.

 

The disc tray comes back

The disc is not placed properly on the disc

Use the disc tray guide to align the disc.

34

out automatically, shortly

 

tray.

 

 

 

after the disc tray is closed.

The disc is dirty or warped.

Refer to “Notes on Discs”.

8, 9

 

Region number does not conform with

If the region number on the disc does not

4

 

 

this unit.

 

match the number on the player, the disc

 

 

 

 

 

cannot be used

 

CD/Audio CD)

The DVD Receiver does

No disc is inserted.

not start playback.

 

 

 

An unplayable disc is inserted.

 

The disc is placed upside down.

 

The disc is not placed within the disc tray

 

 

guide.

 

The disc is dirty.

 

The parental lock function is activated.

Insert a disc. (Check that “DVD,” “VCD,”

34

 

or “CD” is lit in the DVD Receiver’s

 

 

display.)

 

Check the playable discs.

8

Place the disc with the playback side

34

 

down.

 

Place the disc within the proper guide on

34

 

the disc tray.

 

Eject the disc and clean it.

9

Deactivate the parental lock function or

75

 

change the parental lock level.

 

DVD (VIDEO

The playback picture is

The disc is dirty.

Eject the disc and clean it.

9

occasionally distorted.

• It is in fast forward or fast reverse

• Sometimes a small amount of picture

 

 

playback.

 

distortion may appear. This is not a

 

 

 

 

 

malfunction.

 

 

 

 

 

 

 

Brightness is unstable or

Copy protection is activated.

Connect the DVD Receiver directly to the

16, 17

noise is visible on the

 

 

 

TV. Avoid connecting the DVD Receiver to

 

playback picture.

 

 

 

the TV through a VCR.

 

 

 

 

 

The picture from the DVD

• The TV is not set to receive the output

• Set the TV to the DVD Receiver’s input.

Receiver doesn’t appear

 

signals from the DVD Receiver.

 

 

 

on the TV screen.

The DVD Receiver is not properly

Check the connections to the DVD

16, 17

 

 

connected.

 

Receiver.

 

 

 

 

 

Settings are canceled.

• When the power is turned off by power

• Before unplugging the power cord, press

 

 

failure or by unplugging the power cord,

 

STANDBY/ON and check that “--OFF--”

 

 

 

settings will be canceled.

 

disappears in the display.

 

84

Image 84
Contents Contents DVD ReceiverImportant Safeguards AvisPrecautions For U.S. modelFor Canadian model Modèle pour les CanadienFor European model Table of Contents Features Receiver FeaturesDVD/CD Player Features Other FeaturesSupplied Accessories FM antenna aerialAM loop antenna aerial Scart cablePlayable Discs About Video CDsMP3 compatibility information This DVD Receiver can playback the following discsCleaning Discs Handling DiscsDifferences in Disc Composition Storing DiscsIndex to Parts and Controls Front panelDisplay Remote controller Index to Parts and ControlsWhen Mode DVD is selected Number buttons 1-9, +10, 0 35, 52 When Mode Audio is selected SW Mode buttonIPM Intelligent Power Management button SP Setup button 29Rear panel Preparing the Remote Controller Pointing the remote controller in the right directionSwitching the remote controller function modes Inserting the BatteriesConnecting to a TV or projector Before connectingTV or projector Audio/video connection cableConnecting to a TV European model Connecting to a TV Using the Scart CableVideo connection cable Signal flow Audio/videoConnecting to Speakers a How to connect to the speaker connectorsConnecting to Speakers B Front R Front L CenterConnecting Speakers Other models Active Subwoofer Front R Front L CenterSurround R Surround L Configuration of the Front Speakers a system Configuration of the Front Speakers B systemPositioning Speakers For North American and South American modelsConnecting to Audio/Video Equipment VCR, CD Recorder DVD Recorder etcAudio/video connection Connecting to Audio/Video Equipment CD Recorder , Hard DiskRecorder etc MD Recorder, Cassette Tape DeckConnection for the Onkyo MD Recorder or Cassette Tape Deck Onkyo MD recorder/HD Recorder/cassette tape deckConnecting the Supplied FM and AM Indoor Antennas Aerials Connecting an AM Outdoor Antenna AerialAdjusting the position of the FM indoor antenna aerial Adjusting the position of the AM indoor antenna aerialConnecting an FM Outdoor Antenna Aerial Directional IinkageLoosen * North American European modelsSetting the TV System Other than North American model Setting Up the DVD Receiver Using the Setup NavigatorWhen setting up for the first time To exit the Setup NavigatorSetting Up the DVD Receiver Setting the OSD Language On-Screen Display LanguageSetting the TV screen size Confirming the settingsSpeaker Setup Speaker Setup Before operating the remote controller→ Speaker 2ch Speaker 3chSelecting the Subwoofer mode SW ModePress Distance Press UP/DOWN 5/ ∞ to selectFront left and right speaker DistanceAdjusting Each Speakers Relative Volume Balance Test Tone ∞ to adjust the volume levelPress Test Tone Press CH SEL repeatedly to selectGetting Started Using Your DVD Receiver When an operation is prohibitedPlaying DVDs, Video CDs, CDs and MP3s When a Menu Screen is Displayed To Open or Return To the DVD or Video CD Menu ScreenTo navigate a menu screen To play Video CDs without displaying menu screensGetting Started Using Your DVD Receiver Chapter Track Skip Forward/Skip BackForward and Reverse Scanning Press ¢Resuming playback from where you stopped Stopping Playback and Switching Power OffPress 7 once Remove the discTuning Manually Presetting Radio StationsListening to the Radio Selecting Preset Stations Erasing a Preset StationReceiving RDS European models only Various Functions While Listening to Radio ProgramsPlaying the Connected Source Various Functions While Playing the Connected SourceAbout digital sound Enjoying the picture with the sound of another sourcePress Mode CDR first Press Mode Tape MD/HD firstAdjusting the Volume Operating with the remote controllerMuting the Sound Operating with the unitListening Through Headphones Using the Sleep TimerCanceling the Sleep Timer Checking the remaining timeOnkyo’s original Digital Signal Processing DSP modes Enjoying the Sound EffectsDolby PRO Logic II Surround Theater-Dimensional T-D* mode Importance of the speaker setupInput Sources and Available Listening Modes Checking the Sound System of the Playing SourceChoosing Theater-Dimensional Mode Dialog modeEnjoying the Sound Effects Listening angleActivating Theater-Dimensional mode Adjusting Theater-Dimensional modeDisplay, Stereo appears Stereo indicator lights up Saving the adjusted values Adjusting each speaker’s relativeVolume balance Power is switched off unless you save the valuesUsing the Late NIGHT/FRONT Effect Function Boosting the Super Bass Sounds/High Frequency SoundsPress Late Night Still Frame/Slow Play Viewing a still frameViewing slow playback Frame by frame advance playback Viewing one frame at a timeLocating a Specific Title/Folder/Chapter/ Track/Location Using the MP3 Navigator Navigate using the following controlsRepeat Play Repeating a Disc, Title, Folder, Chapter or TrackRepeating a Specific Segment Random Play Playing in Random OrderTo change titles or chapters during random play To stop random playPlaying in a Favorite Order Programming DVDsProgramming Video CDs, CDs To save a program in memoryTo erase a program saved in memory Playing in a Favorites Order Programming MP3sAdditional programming options Selecting the Camera Angle Viewing from a Desired Camera Angle Multi-AngleTo check whether or not a disc is recorded with angles Before operatingChanging the Audio Language Multi- Language Function Selecting a Subtitle Language Multi-Language SubtitlesChanging Audio Type Press Audio repeatedly to select the desired languageRemote controller Press Display during while a disc Viewing Disc InformationViewing Disc Information during while a disc is playing Is playing. Press DisplayViewing Disc Information during while a disc is stopped Video CD and CDCustomizing the Function Settings Using the Setup Screen MenusChanging to the Setup Screen Expert Menu Mode Settings Expert Basic Factory settingCustomizing the Function Settings Setting the TV Screen SizeSettings 43 Letter Box Pan & Scan Wide Factory settingSetting the Video 1 Options Switching the S-Video Output ExpertTurning the Screen Saver On and Off Expert Adjusting the Video Quality Selecting a preprogrammed settingFine Focus ContrastChroma Level HueSetting the Video 2 Options Setting the Position of the On-screen Display ExpertTurning the angle indicator on and off Expert Changing the Background of the ScreenSetting the Language Options Setting the On-screen Display OSD LanguageSelecting an audio language preference Subtitle Language Factory setting English Chinese Other Selecting a subtitle language preferenceSelecting a DVD menu language preference Chinese OtherWhen Other is selected Settings With Audio Selected Subtitle Factory settingForcing subtitles to be displayed Expert Off Assist SubtitleLanguage Code List Language Input-codeSetting the Parental Lock Level Entering the PasswordSetting the Parental Lock Level Changing the PasswordCountry Code List Resetting the DVD Receiver to System SettingsSetting the Country Code Press Enter to set the new Country CodeRecording Using the Connected Equipment Basic Recording ProcedureControlling other components connected to the DVD Receiver Learning a pre-programming codeSetting No Pre-programmong codesControlling other components connected to the DVD Receiver Controlling VCRControlling TV Place the remote controller Remote controller for the otherDesired Mode button on Remote controller, press the EnterControlling other components connected to the DVD Receiver Erasing the programmed command from one button Erasing all the commands programmed under a Mode buttonTroubleshooting Amplifier Symptoms Causes Remedies PagesCD/Audio CD DVD Video CD/Audio CD Symptoms Causes Remedies Pages Troubleshooting Symptoms Causes RemediesTuner Remote controller Recording Specifications Onkyo U.S.A. Corporation Onkyo Europe Electronics GmbHSKS-HT240 Important Safeguards Precautions Introduction SKB-240 Front Speaker Bases Wall Mounting Center Speaker BaseMounting vertically Using Speaker Mounts/Brackets Using the Optional Speaker StandsMounting horizontally Connecting the Speaker Cables Connecting the SubwooferUsing the supplied RCA cable, connect Input terminals to the correspondingEnjoying Home Theater Adjustment Setting the Subwoofer LevelTroubleshooting Symptom Possible cause RemedyPowered Subwoofer SKW-240 Center Speaker SKC-240C Front Speaker SKF-240FSurround Speaker SKM-240S/SKB-240