Silvercrest KH 6507 Required Settings on the DVD Player Before Use, Connecting via Optical Cable

IB_DVD_KH6507_GB.qxd 19.10.2004 9:53 Uhr Seite 14

2Insert the second plug of the coaxial cable into the corresponding socket of the digital audio compo- nent.

Fig. 8 Connecting a HiFi system via coaxial cable

8.2.1.2. Connecting via Optical Cable

1Pull off the protective cover over the optical socket of the DVD player.

2Then insert the plug of the optical cable into the optical socket of the DVD player.

3Insert the second plug of the optical cable into the corresponding socket of the digital audio compo- nent.

Fig. 9 Connecting a HiFi system via optical cable

ôNote:

When connecting the optical cable, dust must not be allowed into the optical socket. This could disrupt the optical signal and cause malfunctions. Place the protecti- ve cover back onto the socket when you disconnect the optical cable!

8.2.2. Connecting via Analog Cable

If the digital audio component does not have a digital input: Connect the digital audio component to the DVD player via RCA cables. To do this:

1Insert one RCA plug each into …

Úthe FL socket

Úthe FR socket

Úthe SL socket

Úthe SR socket

Úthe Center socket and

Úthe Subwoofer socket

on the rear side of the DVD player.

Fig. 10 Connecting a HiFi system via analog cables

2Insert the RCA cables into the corresponding RCA sockets of the digital audio component.

9.Required Settings on the DVD Player Before Use

All settings on the DVD player can be configured with the remote control in the "On-Screen Display Menu". This is displayed on the television screen and is referred to below as the OSD menu.

Before using the DVD player for the first time, you must configure a few settings in this menu.

To be able to configure the required settings via the menu:

1Plug the power cable of the DVD player into a power socket

2To switch on the DVD player, press the Power button on the front side of the DVD player.

If the DVD player is already on, but is currently in standby mode: Press the standby button on the remo- te control once to switch on the DVD player.

The display of the DVD player first displays "Hello", then "Loading" and finally "NoDisc". "No Disc" is displayed on the television screen.

3Familiarise yourself with the operation of the OSD menu with the brief instructions below:

14