NAD T585 owner manual Troubleshooting, Symptoms and Correction, Symptom Cause Correction

T585 Safety.qxd 3/23/2006 4:13 PM Page 34

ENGLISH FRANÇAIS DEUTSCH NEDERLANDS ESPAÑOL ITALIANO PORTUGUÊS SVENSKA

Reference

TROUBLESHOOTING

SYMPTOMS AND CORRECTION

Check the following guide for the possible cause of a problem before contacting service.

SYMPTOM	CAUSE		CORRECTION
No power	• The power cord is disconnected	• Plug the power cord into the wall outlet
			securely.
The power is on, but the DVD player does	• No disc is inserted.	• Insert a disc (Check that the DVD or VCD
not work			indicator in the T585’s display is lit).
No picture	• The TV is not set to receive DVD signal	• Select the appropriate video input mode
	output.		on the TV so that the picture from the
			DVD player appears on the TV screen. See
			page 34 for correct scan types.
	• The video cable is not connected securely.	• Connect the video cable into the jacks
			securely.
	• The connected TV power is turned off.	• Turn on the TV.
No sound	• The equipment connected with the audio	• Select the correct input mode of the audio
	cable is not set to receive DVD signal		receiver so you can listen to the sound
	output.		from the DVD player.
	• The audio cables are not connected	• Connect the audio cable into the jacks
	securely.		securely.
	• The power of the equipment connected	• Turn on the equipment connected with the
	with the audio cable is turned off.		audio cable.
	• The Audio output settings are incorrect.	• Select the digital and analog output
			settings depending on your hardware
			configuration. See page 29 for setup.
The playback picture is poor	• The disc is dirty.	•	Clean the disc.
The DVD player does not start playback	• No disc is inserted.	• Insert a disc (Check that the DVD or VCD
			indicator in the T585’s display is lit).
	• An unplayable disc is inserted.	• Insert a playable disc (Check the disc type,
			colour system and Regional code).
	• The disc is placed upside down.	• Place the disc with the playback side
			down.
	• The disc is not placed within the guide.	• Place the disc on the disc tray correctly
			inside the guide.
	• The disc is dirty.	•	Clean the disc.
	• A menu is on the TV screen.	• Press the SETUP button to turn off the
			menu screen.
The remote control does not work	• The remote control is not pointed at the	• Point the remote control at the remote
properly	remote sensor of the DVD player.		sensor of the DVD player.
	• The remote control is too far from the	• Operate the remote control within about
	DVD player.		23 ft (7 m).
	• There is an obstacle in the path of the	•	Remove the obstacle.
	remote control and the DVD player.
	• The batteries in the remote control are	• Replace the batteries with new ones.
	exhausted.

34