NAD T 531 Preparing the Remote Control, Operating with the Remote Control, Open the battery cover

Page 9

INTRODUCTION

PAGE 9

IdentificationofControls(Cont’d)

Preparing the Remote Control

Insert the batteries into the remote control so you can use it to operate the DVD player.

1	Open the battery cover.

Operating with the Remote Control

This section shows you how to use the remote control.

Point the remote control at the remote sensor and press the buttons.

2	Insert batteries (AAA size).

30° 30°

Within about 23 ft (about 7 m)

●Make sure to match the + and - on the batteries to the marks inside the battery compartment.

3	Close the cover.

Notes on batteries

❍Improper use of batteries may cause battery leakage and corrosion.

❍To operate the remote control correctly, follow the instructions.

❍Do not insert the batteries into the remote control in the wrong direction.

❍Do not charge, heat, open, or short-circuit the batteries. Do not throw the batteries into fire.

❍Do not leave dead or exhausted batteries in the remote control.

❍Do not use different types of batteries together, or mix old and new batteries.

❍If you do not use the remote control for a long period of time, remove the batteries to avoid possible damage from battery corrosion.

❍If the remote control does not function correctly or if the operating range becomes reduced, replace all batteries with new ones.

❍If battery leakage occurs, wipe the battery liquid from the battery compartment, then insert new batteries.

❍The batteries should last about one year with normal use.

POWEROPEN/CLOSE

SETUP REPEAT A-B RANDOM

AUDIO SUBTITLE ANGLE SOUND

TITLE

MENU

SELECT

ENTER

Distance: About 23 ft (7 m) from the front of the remote sensor

Angle: About 30° in each direction of the front of the remote sensor

*Do not expose the remote sensor of the DVD player to a strong light source such as direct sunlight or illumination. If you do so, you may not be able to operate the DVD player with the remote control.

Notes on the remote control

❍Point the remote control at the remote sensor on the DVD player.

❍Do not drop or give the remote control a shock.

❍Do not leave the remote control near an extremely hot or humid place.

❍Do not spill water or put anything wet on the remote con- trol.

❍Do not disassemble the remote control.

Image 9

Contents 531 Service procedure Safety PrecautionsWhen open the enclosure. do not Stare Into Beam This Digital Video Disc Player employs a Laser SystemTable of Contents Cleaning Power SourcesPower-Cord Protection Grounding or PolarizationConnecting Sound Volume AccessoriesHeadphones Damage Requiring ServiceIdentification of Controls Front PanelDisplay window Identification of Controls Cont’d Rear PanelOptical Digital Audio OUT jack Directional arrow buttons Remote ControlOperating with the Remote Control Preparing the Remote ControlOpen the battery cover This section shows you how to use the remote controlOn Handling Discs On Storing Discs On Cleaning DiscsEnjoying Dolby Digital Sound Connecting to Surround Sound SystemDolby Digital DVD recorded in Dolby DigitalEnjoying Dolby Pro Logic Surround Sound Connecting to Surround Sound System Cont’dEnjoying DTS Sound Enjoying 2 Channel Digital Stereo SoundTo S-VIDEO OUT Connecting to a Stereo SystemFor using Component Video OUT jack, set Selection of initial settings Selection of initial settingsPress Setup in the stop or playback mode To exit Setup menuSame method Selecting disc languagesAt the Setup screen, press D/ E to select Selecting rating level and passwordSelecting rating level DVD only Rating and press GTo change/clear memorized password To clear your 4-digit passwordSelecting TV Aspect Selecting Menu Language Selects language for Setup menus and displays On the TVOutput Selecting Digital Audio OutputOthers At the Setup screen, press D/E to select Others and press GDRC Dynamic Range Compression On/Off About DRC Dynamic Range CompressionCode Language Table of Language and Their AbbreviationsBasic Playback Basic Playback Cont’d Automatic power off functionScreen Saver After operationSpecial Playback Playing in slow-motion DVD only To Scan at fast forward or fast Reverse playbackPress the Scan Button during playback To return to normal playback, press PlayGeneral Information about GUI menu icons Common procedures01657 ENG D Detailed description of each GUI menu icon1657 NumericUsing a DVD menu Using a title menuMemorized settings are automatically recalled Memorizing Settings for Viewed DVDs Last Condition MemoryLoad the DVD that was memorized Press F/G to select Yes and pressChanging audio soundtrack language Changing subtitle languageProducing a 3D Surround effect Viewing from another angleRepeat Play Repeating viewing listeningRepeating sections between two specific points A-B repeat Storing markers in memory to be viewed listened to again Storing a marker in the memoryRecalling/Clearing a marker Random play Zoom featureClearing the program Program playTo play an MP3 file repeatedly Playback with MP3 To play an MP3 fileLoad an MP3 disc Press SELECT/ENTER or Play to startPlayback with MP3 Cont’d To program play an MP3 file Disc Requirements/Copyright Information Disc mark Contents Disc size Maximum playback timePlayable Discs Audio CDsBefore Calling Service Personnel Symptoms and CorrectionSymptom Cause Correction Specifications DVD player/Outputs/Supplied AccessoriesDVD player Outputs Supplied Accessories