H & B DRX-430 manual Troubleshooting, Problem Solution

AdditionalInformation

Troubleshooting

Incorrect operation is often mistaken for trouble or malfunction. If you think that there is something wrong with this component, check the points below. Sometimes the trouble may lie in another component. Inspect the other components and electrical appliances being used. If the trouble cannot be rectified after checking the items below, ask your nearest authorized service center or your dealer to carry out repair work.

Problem

Solution

The disc is ejected automatically after	• Dirty or damaged disc
loading.
Disc not seated properly in the disc	• Align the disc properly.
guide.
Incompatible region number.	• If the region number on a DVD-Video disc does not match the number on the
	player, the disc cannot be used.
	• Allow time for condensation to evaporate. Avoid using the player near an air-
Condensation inside the player.	conditioning unit.
	• Playback is not possible.
Disc is loaded upside down.	• Reload the disc with the label side face up.
mark appears on screen.	• The operation is prohibited by the player and / or disc.
Picture playback stops and the	• Switch the power off once using the front panel STANDBY/ON button and then
	switch on again using the front panel STANDBY/ON button.
operation buttons cannot be used.
	• Disconnect the power plug and reinsert it back into the wall.
New settings made in the Setup screen	• Some settings can be changed while a disc is playing, but are not effective
	until the disc is stopped then restarted.
menus while a disc is playing are
	• This is not a malfunction. Make the same setting when the player is stopped.
ineffective.
	• When the power is cut due to power failure or by unplugging the power cord,
Settings are canceled.
	settings will be canceled.
	• Incorrect video connections. Check that connections are correct and that plugs
	are inserted fully.
	• TV/monitor or AV amplifier settings are incorrect. Check the instruction manual
No picture / No color	of the connected equipment.
	• The Component output menu is set to progressive but your TV/monitor is not
	compatible with progressive scan.
	• Reconnect the player to your TV using a composite or S-Video cord and set
	the TV to appropriate input.
	• The type of the disc is wrong, it's not a DVD+RW or DVD+R disc.
The DVD recorder cannot record.	• The disc is recorded fully.
	• The DVD+R has been finailized.
Screen is stretched or aspect does not	• The TV aspect ratio setting in the Setup menu is incorrect. Set the TV aspect
change.	ratio option to match the TV/monitor you're using.
Picture disturbance during playback or	• This player is compatible with Macro-Vision System copy guard. Some discs
	include a copy prevention signal, and when this type of disc is played back,
dark.
	stripes etc., may appear on some sections of the picture depending on the TV.

42 Additional Information