Operating the Receiver, Main Menu, Installation

: This key is used to watch the program information, if there is more information than one page. Use the CH+/CH- keys to move up and down pages.

: Use to display the program list by 30 minutes per block.

BASIC FUNCTIONS

6. Program Information

The electronic program guide gives you a channel list for the channels.

Note : 1. This service depends on service provider.

2.After receiver recognized the GMT-time from the signal which takes few seconds, it can display correct EPG information.

●Press the EPG key while you are viewing a program.

This function is displayed on the screen by using only time.

: Red key is for moving back to the previous date.

●GREEN key : Green key is for moving to the next coming date.

● i key

● / key

Time interval can be adjusted by press keys as followings on EPG screen:

1 Key: 1 hour and 30 minutes 2 key: 30 minutes 3 key: 15 minutes

●Select the channel by pressing the / keys and press the OK key to watch this channel.

After installing your antenna system and STB with appropriate connectors.

●Plug in the AC main power and switch on the receiver.

●Press the MENU key to bring up the main menu.

The sub menu topics will be displayed.

For the sub-menus Installation, Channel Organization and Parental Lock, you need the PIN Code.

This menu consists of 4 sub-menus:

Select Country, Auto Scanning, Manual Scanning and

Reset to Factory Defaults.

●Select “Installation” in the main menu mode to select the sub menu.

●Enter the PIN Code.

If you have not entered your own PIN Code then the

PIN Code 0000 applies, which was set at the factory.

GB-14

D i g i t a l

T e r r e s t r i a l

R e c e i v e r

GB-15