I/O Magic 16X manual Rear Panel

Page 10

Rear Panel

4. Audio output

5.Device configuration jumper

6.Host IDE interface

7.DC input

This is a connector for output of analog audio.

Pin 1 = Left channel

Pin 2 = Ground

Pin 3 = Ground

Pin 4 = Right channel

This is the jumper switch for selection of the drive use mode and supporting PC. The jumper goes on both pins vertically.

MA = Master

SL = Slave

CS = CSEL of

IDE interface.

Reserved = Do not use.

This is a 40-pin I/O connector according to the ATA specifications.

This is the power supply input.

4

Image 10

Contents MagicDVD Page Page Copyright Statement For Europe Table of Contents Introduction CD-ROM-XA CD-R, CD-RW, CD-DAPackage Contents System RequirementsHardware Description Disk tray Busy indicator Eject buttonFront Panel Rear Panel Specifications Handling Static-Sensitive Devices InstallationHost Interface Connections Hardware Installation Setting-up the Mode Select JumperAttaching your MagicDVD 16X DVD-ROM Drive to your computer Connecting to a Primary IDE ControllerConnecting a Secondary IDE controller Turn off the PCLocate an available 5 ¼ drive bay Page Windows 95/98 Installation Driver InstallationSoftware Installation Power DVD Playback SoftwarePage Power DVD Playback Software FeaturesDolby Digital and Mpeg Audio Full-Featured DVD NavigationMPEG-1 and MPEG-2 Video Pdif 5.1-channel Dolby Digital OutputCopy Protection / Decryption For Windows 95 OSR2 or WindowsTo Playback Mpeg Files PowerDVD interfaceTo Playback DVD Titles For WindowsExpress Menu Getting additional helpTroubleshooting Use Registry Editor at your own risk Will my MagicDVD drive read Divx discs?Can I Run Other Programs While Viewing a DVD Movie? Can scratches affect a DVD disk?Whats a hybrid DVD? Page What is the cause of choppy Video/Audio? Contacting I/OMAGIC Phone Fax Internet and e-mail MailRegister Your I/OMAGIC Product DT-DVD16-002 VER