Integra DPS-8.3 Making a digital connection with the amplifier, Audio connection cables

Connecting to an Amplifier (To Enjoy the Sound Advantage of the DVD Player)

Although you can reproduce the DVD Player’s sound from the TV speakers with the connections on pages 15 and 16, connecting

with an amplifier provides you high quality dynamic sounds.

Before connecting

•Refer to the instruction manual of the amplifier.

•When you connect the DVD Player to the amplifier, be sure to turn off the power and unplug both units from the mains before making any connections. Otherwise, the speakers may be damaged.

•Connect the plugs securely.

Incomplete

Notes

•The remote controller supplied with Integra/Onkyo amplifier can be used to operate the DVD player.

•The function of the upper and lower z connectors are the same. Connect to either one.

•Connecting z cable only does not make the system operational. You must also connect the audio cables as well.

•When using the optical input jack, remove the protective cap and keep it safely. When the jack is not used, replace the protective cap.

Insert completely

■Making a digital connection with the amplifier

If your amplifier has a digital input jack, be sure to connect it to either DIGITAL OUTPUT OPTICAL or COAXIAL jack on the DVD player.

Note

DO NOT connect to the AC-3RF input (e.g. of a Dolby Digital receiver) which is reserved only for video disc players.

To ensure proper delivery of sound, be sure to match the names of the jacks on the DVD Player and the component being connected to.

: Signal flow

Be sure to set the digital output setting after connection using the Setup Navigator explained in “Setting Up the Player” starting on page 21 or the function setting menu explained in “Adjusting Audio and Video Settings” starting on page 46.

Audio connection cables

To audio inputs

R (Red)

L (White)

Optical fiber connection cable

To Digital optical jack

Coaxial cable
To coaxial inputs	An amplifier with a Dolby
z cable	Digital/DTS/MPEG1/MPEG2
	decoder
To z jack

	COMPONENT 1	S VIDEO
Y	PB	PR

VIDEO

OUTPUT

CH 1 CH 2 FRONT SURR 1 CENTER

L

ANALOG

OUTPUT R

SUB

WOOFER

VIDEO

SURR 2

L

SURR 1 1+2

R

COMPONENT 2

YPBPR

RS-232

AC INLET

	IR	12V
	IN	TRIG-	SACD & DVD AUDIO/VIDEO PLAYER
		GER	MODEL NO. DPS-8.3
		OUT
	DIGITAL		DO NOT connect
	OUTPUT OUT
OPTICAL	COAXIAL	REMOTE	the mains lead at
		CONTROL	this time.

Note

If you listen to multichannel DVD-Audio through one of the digital outputs, it will be downmixed to stereo. Also, high sampling rate DVD-Audio (192kHz or 176.4kHz) will be downsampled to 96kHz, 88.2kHz, 48kHz, or 44.1 khz, depending on the disc. Multi channel and high sampling rate DVD-Audio is only available through the analog outputs.

Some DVD-Audio and all SACD audio is output only through the analog outputs.

In order to enjoy Dolby Digital/DTS 5.1 channel sound, a separate Dolby Digital decoder, and 5.1 channel (front right/left, center, surround right/left) + subwoofer are required.

17