Samsung WS28V53NS8XXEC, WS32V56VS8XXEC Alignment and Adjustments, General Alignment Instructions

Page 14

Alignment and Adjustments

4. Alignment and Adjustments

4-1 General Alignment Instructions

1.Usually, a color TV-VCR needs only slight touch-up adjustment upon installation. Check the basic characteristics such as height, horizontal and vertical sync and focus.

2.Observe the picture for good black and white details. There should be objectionable color shading; if color shading is present, demagnetize, perform purity and convergence adjustments described below.

3.Use the specified test equipment or its equivalent.

4.Correct impedance matching is essential.

5.Avoid overload. Excessive signal from a sweep generator might overload the front-end of the TV. When inserting signal markers, do not allow the marker generator to distort test results.

6.Connect the TV only to an AC power source with voltage and frequency as specified on the backcover nameplate.

7.Do not attempt to connect or disconnect any wires while the TV is turned on. Make sure that the power cord is disconnected before replacing any parts.

8.To protect against shock hazard, use an isolation transformer.

4-2 Automatic Degaussing

A degaussing coil is mounted around the picture tube, so that external degaussing after moving the TV should be unnecessary. But the receiver must be properly degaussed upon installation.

The degaussing coil operates for about 1 second after the power is switched ON. If the set is moved or turned in a different direction, the power should be OFF for at least 10 minutes.

If the chassis or parts of the cabinet become magnetized, poor color purity will result. If this happens, use an external degaussing coil. Slowly move the degaussing coil around the faceplate of the picture tube and the sides and front of the receiver. Slowly withdraw the coil to a distance of about 6 feet before turning power OFF.

If color shading persists, perform the following Color purity and Convergence adjustments.

4-3 High voltage Check

CAUTION : There is no high voltage adjustment on this chassis. The B+ power supply should be +135 volts (with full color- bar input and normal picture level).

1.Connect a digital voltmeter to the second anode of the picture tube.

2.Turn on the TV. Set the Brightness and Contrast controls to minimum (zero beam current).

3.Adjust the Brightness and contrast controls to both extremes. Ensure that the high voltage does not exceed 32 KV under any conditions.

Samsung Electronics

4-1

Page 13 Page 15
Image 14
Page 13 Page 15
Contents Color Television Receiver Chassis KS3AP50HzREV Model WS28V53NS8XXECSamsung Electronics PrecautionsSafety Precautions Samsung Electronics Servicing Precautions Precautions for Electrostatically Sensitive Devices ESDs Reference Information Reference InformationTables of Abbreviations and Acronyms Km/h Kilometer Per Hour RpsLED ABLACC AFCEeprom LOC. no Spec Description RemarkMICOM, Ttxmtp FML-G12SSpec Function Remark Board LOC. no Spec Description RemarkFocus TCPS3000P CZ, CWMemo VHS SpecificationsPAL/SECAM-B/G,D/K,L,I, NTSC-M Tuner PIP, A2 StereoMemo Automatic Degaussing Alignment and AdjustmentsGeneral Alignment Instructions High voltage CheckDynamic Focus Adjustment Screen AdjustmentCDL E2PROM IC902 Replacement White Balance AdjustmentSamsung Electronics Factory Adjustment Service ModePIP OSDSize PIP BlklgSIM-806EW1SEH Initial Data 2B Screen Change I2C BUS Geometric Adjustment PAL-M Y/C Delay NTSC-M YC DelaySED AK DVD Stretch-BTLT Adjust RGB input signal brightnessAdjust RGB input signal contrast Black stretch tilt positionOSD Range Initial Data OSDVSU Flat Initial DataSIM-806EW1HQ SIM-812MA3 SIM-806MA3HB Start 2E Video 3 AdjustAccrsecam HB StopPeak Video Ref Fix Peak Video Gain Peak ThresholdSoft Limit Slope B Fix Hard Limit 255Initial Data OSD Range Gain1Video Fix Delay1Video Velocity LimitVelocity Delay Fix Velocity Coring RGB Shift 2H CombFilter Fix NR Off ValueLNA TTX TOPAKB AV by CH Key CW29A7 CZ29A6 CZ29A7CW21A8 OffSIM-806E1 SIM-812EA129A7NTBX 29A5WBX 29A5NTBX 29K3WTBX 29K3WBX 29A7PFBX 29A5PFBX 29A6NTBX 29A7PNBXMrcb MrcrMrcg MrwdgWide SEDColr SIMZoom Parabola Melody VolumeQEW Parabola30 ~ Melody Volume96 ~111 Parabola 30 ~Dscc BOWAngle DVD SUB Tint5 5 5 IN/OUT Assign DescriptionAssign IN/OUT Active H/L Description Troubleshooting TroubleshootingNo Power IC201S #31 No PictureIf the deflection is in operation Check CRT and FBTNo Sound Memo Exploded View & Parts List WS28V53NS8XXEC32V5Electrical Parts List WS28V53NS8XXECPIN-GT,ASSYAUTO GT409 GT103J621 J622EYELETID2.0,OD2.8,BST TOP2 EYELETID2.0,OD2.8,BSTEYELETID2.0,OD2.8,BST TOP1 EYELETID2.2,OD3.2,BSP Labellabel PCBIC HYBRID-,DRGB001A,SIP,5P,-,TP LDY01 TOPBAND-TIENYLON66 V2,L100,NTR CNY02CNF01 Assy ETC-PCB A/V BoardHA98-00003A Assy SUB PARTASSY-SUB,PARTS53A,PCB,CRT JACK-PHONE1PVER,3.4PI,AG,BLK,NOHA83-00006A LP-RESIN HIPS,BASF495F,NTR,HB PFT01HA98-600020 ASSY-SUB,PARTKS4A,PFC PCB CNP02SUB ETC-MICA,MICA,22X30X0.1MM Assy ACCESSORY50HZ,KS3A,XECWS28V55VS8XXEC D906 D804DZ402 D604J209 3812-000219 J208 3812-000219J811 3812-000219 J816 3812-000219EY302 J430EY301 EY303C234 R233C233 C235IC HYBRID-,DDRI001A,SIP,5P,-,TP IC2 SOLDER-WIRE FLUXCF-110VH-2AIC1 JP1SWY04 SWY02SWY03 SWY05EYP08 HA98-00054A Assy SUB Partassy SUB PARTKS3A,PCB,CRTEYP07 EYP09Assy Cabinet Front WS32V56VS8XXEC C838 AL100uF,20%,16V,GP,TP,6.3x11,5 GT302 C634 AL100uF,20%,16V,GP,TP,6.3x11,5 GT102C832 AL100uF,20%,16V,GP,TP,6.3x11,5 GT301 C826 AL100uF,20%,16V,GP,TP,6.3x11,5 GT401J411 J121J254 C2322001-000290 R432 R231R232 VARISTOR750V,1250A,12.5x7mm,TP R913INDUCTOR-AXIAL33uH,5%,2.5x3.4mm C106 AL47uF,20%,50V,WT,TP,6.3x11,2.5AL100uF,20%,16V,WT,TP,6.3x11,5 INDUCTOR-AXIAL33uH,5%,2.5x3.4mm C303ICS01 HA98-600012 ASSY-SUB,PARTPCB-WIDE,S51A,WIDE DZS01DZS02 CNG01JACK-PIN1P,1PI,NI,RED,SCR-JACK Assy SUB PARTS51A,CONTROL WideASSY-CRT AA69-00744F Block Diagrams Block Diagram Wiring Diagram Memo Samsung Electronics 10-1 Schematic DiagramsMain TP12 TP13 TP11 TP25 TP14 TP15 MAIN3 Samsung Electronics 10-3TP26 TP27 TP32 TP31 TP28 TP29 TP30 PIP MODULE, Switch Module PIP Module Samsung Electronics 10-510-6 CRT Wtih in V/M Wtih out V/M Samsung Electronics 10-7 Electronics
Top Page Image Contents