Alignment and Adjustments
4-8-2(H) OTHERS
No. | OSD |
|
|
| Function |
|
|
|
| ||||
|
| Vertical Setup Time. Delays the vertical sync to solve the jitter of OSD and TTX . | ||||
|
| Check OSD while varying 96 ~ 111 step by step and an 1H line moves at two points. | ||||
1 | VSU | If the value is set at the first point or second point, an OSD jitter may happen. Also, if the | ||||
|
| value is set between the first andsecond points, a TTX jitter may happen. So, the value of | ||||
|
| VSU should be set after giving some magines (three steps). | ||||
|
| Short for | ||||
|
| mode, the horizontal picture size is within 5 ~ 5.5. |
| |||
2 | H QEW | In Q mode, the horizontal picture size is within 6.5 ~ 7. |
| |||
|
| This H QEW function sets the gap between horizontal picture size in NORMAL mode and | ||||
|
| horizontal picture size in Q mode. |
| |||
3 | H ZOOM PARABOLA | In ZOOM mode of | ||||
(Refer 'other' data) |
|
|
| |||
|
|
|
|
| ||
4 | H 16:9 PARABOLA | In 16:9 mode of | ||||
(Refer 'other' data) |
|
|
| |||
|
|
|
|
| ||
5 | TTX H SHIFT | Adjusts TTX horizontal position |
| |||
6 | MONO SOUND SYSTEM | NOT USED, KS3A chassis has no function of Mono sound system. | ||||
|
| Allows the sync slice level of sync separate block to be changed. This item corresponds the | ||||
7 | V SLICE LEVEL | case where a vertical bouncing happens according to signal conditions by area. | ||||
(overmodulation, especially). |
|
| ||||
|
|
|
| |||
|
| 0: 100% | 1: 90% | 2: 75% | 3: 60% |
|
8 | MELODY VOLUME | Sets the level of melody volume in Picture ON. It is managed differently according to buyer or | ||||
area. |
|
|
|
| ||
|
|
|
|
|
| |
|
| Short for Auto Kined Bias, a function that maintains uniformity inbrightness and white balance | ||||
9 | AKB | by automatically correction the variance of brightness and white balance according to | ||||
|
| temperature and characteristics of AMP in the CRT drive |
| |||
|
| TTX mode has two different types; List and FLOF. When swtiching into the TTX mode, this | ||||
10 | TTX LIST PRIOR | function determines which type has priorty. |
| |||
|
| On : Australia Off : others country |
| |||
11 | MAIN NEWLIN | Controls the picture compressing rate. |
| |||
12 | Main PFGHB | Controls the horizontal blanking when the picture size compressed. | ||||
13 | PIP BLKLR | PIP blanking level red(PIP low light white balance). Adjust | low light white balance of PIP. | |||
|
|
|
| |||
14 | PIP BLKLB | PIP blanking level blue(PIP low light white balance). Adjust | low light white balance of PIP. | |||
15 | PIP PKLR | PIP peak white level Red. Adjusts high lignt white balance of PIP. | ||||
16 | PIP PKLG | PIP peak white level Green. Adjusts high lignt white balance of PIP. | ||||
17 | PIP PKLB | PIP peak white level Blue. Adjusts high lignt white balance of PIP. |
Samsung Electronics |