Samsung DVD-R150 Sound, Remote Control Unit, Timer Recording, Hdmi DVD-R155 only, Other

Sound
▌
No sound.
Checkpoint 1	Are you watching a programme in slow or
	skip mode?
	If you are playing a programme at a speed
	other than normal or fast 1 speed, sound will

Abnormal HDMI output screen.

Checkpoint 1 If snow noise appears on the screen, it means that TV does not support HDCP (High-bandwidth Digital Content Protection).

HDMI output Jitter

	not be heard.
Checkpoint 2	Check the connections and settings.
	(See pages 17~18, 27~28)
Checkpoint 3	Check whether the disc is damaged.
	Clean the disc, if necessary.
Checkpoint 4	Check whether the disc is inserted correctly
	with the label facing up.
No audio output.

Checkpoint 1

Checkpoint 2

Checkpoint 3

Check your TV system setup correctly.

Screen Jitter may occur when the frame rate is converted from 50Hz to 60Hz for 720p/1080i HDMI (High Definition Multimedia Interface) Output.

Please refer to the user’s manual of your TV.

Checkpoint 1	Check whether you have selected the correct
	digital output options in the Audio Output

▌Remote Control Unit

The remote control doesn't work.

Options menu. (See page 27)

Timer Recording

▌

Timer lamp flickers.

Checkpoint 1 Check there is enough space in the disc for

recording.

Checkpoint 1

Checkpoint 2

Checkpoint 3

Point the remote control at the remote control sensor on your DVD recorder.

Allow for proper distance. Remove obstacles between your DVD recorder and the remote control.

Check whether the batteries are empty.

Check for the TV or DVD selection button.

Checkpoint 2	Check whether the current disc is recordable
	or not.
	Make sure to check before the start time of
	recording.

Timer recording does not work properly.

Checkpoint 1	Re-check the recording time and the end time
	settings again.
Checkpoint 2	Recording will be cancelled if the power is
	interrupted due to a power failure or another
	similar reason while recording.

▌HDMI (DVD-R155 only)

No HDMI output.

Checkpoint 1 Check the Video output is HDMI enabled.

Checkpoint 2 Check the connection between the TV and

▌
Other
I forgot my password for parental supervision.
Checkpoint 1	Press and hold down the STOP (	) button
	on the front panel of the DVD Recorder
	simultaneously for more than 5seconds with
	no disc in the DVD Recorder. All settings

including the password will revert to the factory settings.

Do not use this unless absolutely necessary. (Note that this function is possible only when no disc is inserted.)

Is it possible to change a subtitle and an audio signal on a recorded disc?

Checkpoint 1	A recorded disc is played with only the
	subtitle and the audio signal which were
	selected during recording.

Other problems.

A

the HDMI jack of the DVD Recorder.

Checkpoint 3 See if your TV supports this 576p/720p/1080i DVD Recorder.

Checkpoint 1

Checkpoint 2

Checkpoint 3

Read the table of contents and then find and read the section describing your problem, follow the instructions given.

Turn your DVD recorder off and on.

If the problem still persists, contact a nearby Samsung service centre.

dditional Information

English - 69