Connecting the Cables

1. Power cable

2. Master/slave select terminal

3. IDE cable

4. Audio cable

1 Connecting the power cable

The 4-pin power cable from the internal power unit of your computer must be connected to the power terminal on the rear of the DVD-ROM drive.

2 Installing a jumper on the master/slave select terminal

Install the jumper in the correct position on the terminal:

MA to use the device in the master mode

SL to use the device in the slave mode

CS to control the device via a CSEL host interface signal

See Step 3 for further details.

3 Connecting the IDE cable

Two configurations are possible.

●The DVD-ROM drive is the only IDE device in addition to the hard disk.

Setting Up the Device Driver

◆Automatic Setup

1Insert the setup diskette in the diskette drive and change the directory to A:, where A: is the diskette drive.

To do so, type A: after the C:\ prompt and press [Enter].

2Type CDSETUP and press [Enter].

3Reboot the computer.

◆Manual Setup

1 Make the C:\SAMSUNG directory.

2 Copy the files from the diskette to the C:\SAMSUNG directory.

To do so, type COPY A:*.* C:\SAMSUNG after the C:\ prompt and press [Enter].

3 Edit the CONFIG.SYS file.

IDE port

Mother board

DVD-ROM	Hard disk
(SL)	(MA)

Install the jumper in the SL position (Slave). Connect the 40-pin flat IDE cable from the IDE port on the mother board, first to the DVD-ROM drive and then to the hard disk.

Add the DEVICE=C:\SAMSUNG\SSCDROM.SYS \D:SSCD000 /V entry.

LAST DRIVE = Z

- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -

DEVICE = C :\SAMSUNG\SSCDROM.SYS /D : SSCD000 /V

●You already have an additional IDE device installed in your computer.

Second IDE cable

First IDE cable

			Install the jumper in the MA position (Master).
			Connect the 40-pin flat IDE cable from a second
		Mother	IDE port on the mother board directly to
		Mother	the DVD-ROM drive or first to another additional
		board	the DVD-ROM drive or first to another additional
		board	IDE drive and then to the DVD-ROM drive.
DVD-ROM CD-ROM			IDE drive and then to the DVD-ROM drive.
DVD-ROM CD-ROM		Hard disk	Hard disk
(MA)	(SL)	(SL)	(MA)

4 Connecting the audio cable from a sound card

Connect the 4-pin audio cable between the sound output terminal on the DVD- ROM drive and the audio input terminal on the sound card.

4 Edit the AUTOEXEC.BAT file.

Add the C:\SAMSUNG\MSCDEX /D:SSCD000 entry.

- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -

C :\SAMSUNG\MSCDEX /D:SSCD000

5 Reboot the computer.