Samsung DCB-9401V manual Troubleshooting, Technical Specifications, Disposal

DCB-9401V

TROUBLESHOOTING

Problem	Possible cause	Solution of the problem
No display LED on	Power cord	Power cord plug in correctly
the front panel;	not plugged in correctly
No power supply
No pictures on the screen	Receiver in Standby mode;	Set receiver to “On”;
	SCART not connected tightly	Check connection and correct;
	to video output of television;
	incorrect channel or video	Check channel and video output and
	output selected on television	correct (TV instruction manual)
No sound	Scart cable connected	Check connection and correct;
	incorrectly;
	Volume level = 0;	Increase volume on television set;
	Muting active	Press the MUTE key
Remote Control does not	Batteries dead or inserted	Point remote control towards the
operate directly	incorrectly	Receiver.
		Replace batteries or insert correctly
Poor picture quality	Signal strength too low	Check the signal strength in
		the “Installation” menu, correct
		alignment of your signal cable
On-Screen Error Message	Signal cable not connected	Check connection and correct;
“Searching for signal”	or not tight;
	incorrect position of the	Check position and correct,
	signal;	Check the signal strength in
		the “Installation” menu
On-Screen Error Message	Receiver not yet set	Scanning of in “Installation” menu
“No channels are stored.”
On-Screen Error Messages:	Smartcard:	(depending on models)
“Channel is not entitled.	- not plugged in correctly;	Check the Smartcard.
Please check the card.”;	- not plugged in.	“Insert the Smartcard.”
“Please insert the
Smartcard”.
On-Screen Error Message	No access to this channel	Check that you subscribe to this channel.
“No access”		If the STB has been switched off for a
		longer period of time, turn on the STB,
		select any channel, and wait for
		authorization for up to 60 minutes.

TECHNICAL SPECIFICATIONS

Power supply
Type :	SMPS
Input Voltage :	AC 100 - 240V~, 50/60 Hz
Fuse rating :	250 V/T1.6 AH
Power Consumption :	Max. 10W
Stand by :	7W
Tuner & Demodulator
Input Frequency :	VHF,UHF BAND(50~870 MHz)
DEMODULATION :	QAM DVB-C
SYMBOL RATE :	MAX 7 Msps
Constellation :	16, 32, 64, 128, 256 QAM
CABLE OUT :	LOOPOUT FOR ANALOG RECEIVER
Video decoder
System decoding :	MPEG 2 ISO/IEC 13818
	(Transport Stream)
Profile and level :	MPEG 2 MP@ML (4:2:2)
Data rate :	1~ 15 Mb/s
Video formats :	4:3 (normal) & 16:9 (widescreen)
Picture resolution :	720(H) x 576(V) x 50 fields/sec
Audio Decoder
System decoding :	MPEG 1 ISO/IEC 11172~3 layer I & II
Audio mode :	single channel, dual channel, stereo,
	joint stereo
Sampling frequency :	32, 44.1, 48 KHz

Note : The specification of the STB may be changed without notice in advance.

DCB-9401V

GB

DISPOSAL

The device, packaging material (e.g. Styrofoam) and the batteries must never be disposed of with household refuse.

Please obtain appropriate information about the regulations in your community, and dispose of all refuse in accordance with regulations at the separate locations provided.

GB-28 D I G I T A L C A B L E R E C E I V E R GB-29