Samsung TSL 2795HF, TSK3290F, TSK2790F, TSL3294HF Labeling the Channels, Press the VOL + button

Page 31

O P E R AT I O N

Labeling the Channels

Use this feature to assign an easy-to-remember label to any channel (i.e., “CBS”, “ESPN”, “PBS2”, CNN1”, etc.) A label consists of four fields, where each field is a letter, a num- ber, “*”, or a blank. When the Display button is pressed, the channel label will appear next to the channel number.

1

Press the CH ▲ or CH ▼ button to tune to the channel that will be labeled.

2

Press the Menu button to dis- play the menu.

Press the CH ▼ button twice to highlight “CHANNEL”.

▼	Note: You cannot select

“Labeling” in the A/V mode.

Press the VOL + button.

3

Press the CH ▼ button five times to select “Labeling”.

Press the VOL + button to begin labeling. The left-most field will be highlighted.

(Each label has four fields. See top paragraph.)

4

Press the CH ▲ or CH ▼ but- ton to select a letter, anumber, “*”, or a blank. (Pressing the CH ▲ button results in this sequence: A, B, ...Z, *, blank, 0, 1,... 9).

5

Press the VOL+ button to switch to the next field, which will be highlighted. Select a second letter or digit using the the CH ▲ and CH ▼ buttons, as above.

Repeat the process to select the last two digits.

Press Menu twice to set the label and clear the menus from

the screen.

CHAPTER THREE: TV OPERATION 3.9

Image 31

Contents Owner’s Instructions As an Energy Star Partner Thank You for Choosing Samsung Example Antenna Grounding Your New TV InstallationOperation Troubleshooting Special FeaturesChapter One List of FeaturesFamiliarizing Yourself with The TV Used to connect the audio Side Panel JacksAudio in jacks Super Video in jack ´ Video in jackSuper Video Rear Panel JacksAUDIO-VIDEO ¨ CH and CH Channel Up/Down Remote Control´ +100 Mute¯ V.chip Option Remote Control DisplaySleep ˜ AspectAntennas with 300-ohm Flat Twin Leads Connecting VHF and UHF AntennasCable without a Cable Box Connecting Cable TVAntennas with 75-ohm Round Leads Separate VHF and UHF AntennasConnecting to a Cable Box that Descrambles Some Channels Connecting to a Cable Box that Descrambles All ChannelsConnect this cable to a two-way splitter Install AT I O N Unplug the cable or antenna from the back of the TV Connecting a VCRConnecting a Second VCR to Record from the TV Connecting an S-VHS VCRConnecting a Digital TV Set-Top Box Connecting a DVD PlayerSee Connecting a Surround SpeakersConnecting a Camcorder Installing Batteries in the Remote Control Press Power button Plug & Play FeatureTurning the TV On and Off Press the Menu button If you want to reset this featureViewing the Menus Viewing the Menus and On-Screen DisplaysViewing the Display Selecting a Menu Language Memorizing the Channels Selecting the Video Signal-source Storing Channels in Memory Automatic Method Changing Channels Using the Channel ButtonsDirectly Accessing Channels Using the Pre-CH Button to select the Previous ChannelUsing Mute Adjusting the VolumePress the VOL + button Labeling the ChannelsOption 1 Setting the Clock Manually Setting the ClockPress the CH or CH buttons to select the correct minutes Press the Menu button to display the menu E R AT I O N Customizing the Picture Alternate method Using Automatic Picture SettingsCustomizing the Sound Using Automatic Sound Settings Press the TV/Video but- ton to exit Viewing a VCR or Camcorder TapeSetting Up Your Remote Control to Operate Your VCR or DVD Customizing Your Remote ControlTurn off your VCR or DVD Codes VCR CodesCable Box Setting Up Your Remote Control to Operate Your Cable BoxCodes Select the appropriate channel Fine Tuning ChannelsPress the CH button twice to highlight Channel Press the Menu button to display the menu LNA Low Noise AmplifierDigital Noise Reduction Press the VOL+ button TiltFor models TSK3092WF/TSL3095WHF Changing the Screen SizePress the Aspect button to chang the screen size Freezing the Picture Using the R.SurfDolby Pro Logic Choosing a Multi-Channel Sound MTS Soundtrack Press the VOL+ or VOL- buttons to select Main or Sub Adjusting the Headphone SoundAuto Volume Switching the Internal Speakers On/Off Press the CH button to select On time Setting the On/Off TimerPress the Sleep button on the remote control Setting the Sleep TimerViewing Closed Captions Press the CH button to highlight ModePress the Menu button three times to exit Activating Picture-in-Picture Viewing Picture-in-PictureChanging the Location Rotating the PIP Window Selecting a Signal Source External A/V for PIPSwapping the Contents of the PIP image and Main image Changing the PIP ChannelSetting Up Your Personal ID Number PIN Using the V-Chip OptionDigits for your PIN and enter them How to Set up Restrictions Using the TV guidelines How to Enable/Disable the V-ChipMature audience General audienceParental guidance TV-14Press the CH button six times to select the V-chip menu NC-17No children under age Adults only NR Not rated Chapter Five Identifying ProblemsUsing Your TV in Another Country Cleaning and Maintaining Your TVSpecifications