Samsung PCJ 614RF, PCK 6115R, PCJ 534RF manual Risk of Electric Shock Do not Open

Page 2

Warning! Important Safety Instructions

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

This symbol indicates high voltage is present inside. It is dangerous to make any kind of contact with any inside part of this product.

This symbol alerts you that important literature concerning operation and maintenance has been included with this product.

Note to CATV system installer: This reminder is provided to call CATV system installer’s attention to Article 820-40 of the National Electrical Code (Section 54 of Canadian Electrical Code, Part I), that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building as close to the point of cable entry as practical.

Caution: FCC/CSA regulations state that any unauthorized changes or modifica- tions to this equipment may void the user’s authority to operate it.

Caution: To prevent electric shock, match the wide blade of plug to the wide slot, and fully insert the plug.

Attention: pour eviter les chocs electriques, introduire la lame le plus large de la fiche dans la borne correspondante de la prise et pousser jusqu’au fond.

Important: One Federal Court has held that unauthorized recording of copyrighted TV programs is an infringement of U.S. copyright laws.

Certain Canadian programs may also be copyrighted and any unauthorized recording in whole or in part may be in violation of these rights.

To prevent damage which may result in fire or electric shock hazard, do not expose this appliance to rain or moisture.

Image 2

Contents Owner’s Instructions Risk of Electric Shock Do not Open Thank You for Choosing Samsung Example Antenna Grounding FCC Information Operation InstallationYour New TV Special Features TroubleshootingList of Features Chapter OneFamiliarizing Yourself with The TV ´ Video in jack Front Panel JacksSuper Video in jack Audio in jacks Audio Inputs Rear Panel JacksSuper Video Connect to an antenna or to a cable TV system+100 PIPNumber buttons ˝ CH and CH Channel Up/DownRemote Control ¸ VCR controls For model PCJ533RF PIP ControlsOtherwise, the picture may Flicker For model PCJ532RF/PCJ534RFPCK6115R Connecting VHF and UHF Antennas Antennas with 300-ohm Flat Twin LeadsSeparate VHF and UHF Antennas Connecting Cable TVAntennas with 75-ohm Round Leads Cable without a Cable BoxConnect this cable to a two-way splitter Connecting to a Cable Box that Descrambles All ChannelsConnecting to a Cable Box that Descrambles Some Channels Connecting a VCR Unplug the cable or antenna from the back of the TVConnecting an S-VHS VCR Antenna or cable to your VCR and your TVConnecting a Digital TV Set-Top Box Connecting a Second VCR to Record from the TVConnecting a Camcorder Installing Batteries in the Remote Control Turning the TV On and Off Adjusting Basic ConvergencePress Power Adjust Red Convergence To do Left or Right ConvergenceViewing the Menus With the power on, press MenuViewing the Menus and On-Screen Displays Viewing the DisplaySelecting a Menu Language Memorizing the Channels Selecting the Video Signal-sourcePress CH two times to highlight SET UP Press VOL + Press MENU, then press CH twice to highlight SET UP Storing Channels in Memory Automatic MethodChanging Channels Using the Channel ButtonsDirectly Accessing Channels Adding and Erasing Channels Manual MethodPress Menu three times to exit Setting the ClockPress the CH or CH button to select the correct minutes Press VOL + or VOL to increase or decrease the volume Adjusting the VolumeUsing Mute Customizing the Picture Video icon will be highlighted starts blink- ingUsing Automatic Picture Settings Alternate methodCustomizing the Sound Press Menu to display the menuUsing Automatic Sound Settings Press TV/VIDEO to exit Viewing a VCR or Camcorder TapeVideo1 Video2 Video3 Turn off your VCR or Customizing Your Remote ControlSetting Up Your Remote Control to Operate Your VCR Turn off your cable box Setting Up Your Remote Control to Operate Your Cable BoxVCR Codes DVD Codes Cable Box CodesSetting the On/Off Timer Press CH or CH to select the appropriate minutesPress the Sleep button on the remote control Setting the Sleep TimerWhen finished, press Press VOL+ to open Caption menu Viewing Closed CaptionsPress VOL+ Fine Tuning Channels Select the appropriate channel Press MenuLNA Low Noise Amplifier Press CH twice to highlight LNASpecial Audio Options Dolby Surround, MTS, and Headphones Dolby PrologicDolby 3D Phonic Drama, Action, or TheaterChoosing a Multi-Channel Sound MTS Soundtrack Press CH to highlight MTSUsing Wireless Headphones Setting up Wireless Headphones with Picture-in-PicturePress VOL + to select PIP menu Viewing Picture-in-PictureActivating Picture-in-Picture Press VOL + to select PIP OnSwapping the Contents of the PIP image and Main image Selecting a Signal Source Antenna or Cable for PIPSelecting a Signal Source External A/V for PIP Freezing the PIP Image Changing the PIP ChannelChanging the Location Rotating the PIP Window Changing the Size of the PIP WindowPress CH six times to select the V-chip menu Press VOL+ Using the V-ChipSetting Up Your Personal ID Number PIN How to Enable/Disable the V-Chip How to Set up Restrictions Using the TV guidelinesParental guidance TV-Y Young children TV-Y7 Children 7 and overGeneral audience TV-14E C I a L F E AT U R E S NC-17 Identifying Problems Chapter FiveSpecifications Cleaning and Maintaining Your TVUsing Your TV in Another Country