Samsung PCK 6115R, PCJ 534RF, PCJ 614RF manual NC-17

Page 56

S P E C I A L F E AT U R E S

3

The “V-chip mode” screen will appear. Press the CH ▼ button twice, and highlight “MPAA rating.”

4

While “MPAA rating” is highlighted, press the VOL + button. The “MPAA rat- ing” screen will appear.

5

Repeatedly press the CH ▼ button to highlight a particular MPAA category. (When a category is highlighted, its color changes to blue.) Pressing the CH ▼ button will cycle through the MPAA categories:

G

PG

PG-13

R

NC-17

X

NR

General audience (no restrictions).

Parental guidance suggested.

PG-13 (Parents strongly cautioned).

R (Restricted. Children under 17 should be accompanied by an adult).

No children under age 17.

X (Adults only).

Not rated.

While a particular category is highlighted, press VOL + to activate it.

A blinking letter (“U” or “B”) will be displayed. Press CH ▲ or CH ▼ to select “U” or”B”.

Press MENU three times to save the settings and to clear all screens.

Note: The V-Chip will automatically block any category that is “more restrictive.” For example, if you block the “PG-13” category, then “R,” “NC-17,” and “X” will automatically be blocked also.

How to Reset the TV after the V-Chip

Blocks a Channel (“Emergency Escape”)

If the TV is tuned to a restricted channel, the V-Chip will block it. The screen will go blank and the following message will appear: “Excessive rating.”

To resume normal viewing, tune to a different channel using the number buttons. Under certain conditions (depending on the rating of the local TV programs) the V-Chip might lock out all the channels. In this case, use the V-Chip button for an “emergency escape”:

Press the V-chip button on the remote control. Enter your PIN number, and press VOL + to temporarily disable the V-Chip Lock.

4.20 CHAPTER FOUR: SPECIAL FEATURES

Image 56
Contents Owner’s Instructions Risk of Electric Shock Do not Open Thank You for Choosing Samsung Example Antenna Grounding FCC Information Operation InstallationYour New TV Special Features TroubleshootingList of Features Chapter OneFamiliarizing Yourself with The TV ´ Video in jack Front Panel JacksSuper Video in jack Audio in jacks Rear Panel Jacks Super VideoAudio Inputs Connect to an antenna or to a cable TV systemPIP Number buttons+100 ˝ CH and CH Channel Up/DownRemote Control ¸ VCR controls For model PCJ533RF PIP ControlsOtherwise, the picture may Flicker For model PCJ532RF/PCJ534RFPCK6115R Connecting VHF and UHF Antennas Antennas with 300-ohm Flat Twin LeadsConnecting Cable TV Antennas with 75-ohm Round LeadsSeparate VHF and UHF Antennas Cable without a Cable BoxConnect this cable to a two-way splitter Connecting to a Cable Box that Descrambles All ChannelsConnecting to a Cable Box that Descrambles Some Channels Connecting a VCR Unplug the cable or antenna from the back of the TVConnecting an S-VHS VCR Antenna or cable to your VCR and your TVConnecting a Digital TV Set-Top Box Connecting a Second VCR to Record from the TVConnecting a Camcorder Installing Batteries in the Remote Control Turning the TV On and Off Adjusting Basic ConvergencePress Power Adjust Red Convergence To do Left or Right ConvergenceWith the power on, press Menu Viewing the Menus and On-Screen DisplaysViewing the Menus Viewing the DisplaySelecting a Menu Language Memorizing the Channels Selecting the Video Signal-sourcePress CH two times to highlight SET UP Press VOL + Press MENU, then press CH twice to highlight SET UP Storing Channels in Memory Automatic MethodUsing the Channel Buttons Directly Accessing ChannelsChanging Channels Adding and Erasing Channels Manual MethodPress Menu three times to exit Setting the ClockPress the CH or CH button to select the correct minutes Press VOL + or VOL to increase or decrease the volume Adjusting the VolumeUsing Mute Customizing the Picture Video icon will be highlighted starts blink- ingUsing Automatic Picture Settings Alternate methodCustomizing the Sound Press Menu to display the menuUsing Automatic Sound Settings Press TV/VIDEO to exit Viewing a VCR or Camcorder TapeVideo1 Video2 Video3 Turn off your VCR or Customizing Your Remote ControlSetting Up Your Remote Control to Operate Your VCR Turn off your cable box Setting Up Your Remote Control to Operate Your Cable BoxVCR Codes DVD Codes Cable Box CodesSetting the On/Off Timer Press CH or CH to select the appropriate minutesPress the Sleep button on the remote control Setting the Sleep TimerWhen finished, press Press VOL+ to open Caption menu Viewing Closed CaptionsPress VOL+ Fine Tuning Channels Select the appropriate channel Press MenuLNA Low Noise Amplifier Press CH twice to highlight LNASpecial Audio Options Dolby Surround, MTS, and Headphones Dolby PrologicDolby 3D Phonic Drama, Action, or TheaterChoosing a Multi-Channel Sound MTS Soundtrack Press CH to highlight MTSUsing Wireless Headphones Setting up Wireless Headphones with Picture-in-PictureViewing Picture-in-Picture Activating Picture-in-PicturePress VOL + to select PIP menu Press VOL + to select PIP OnSwapping the Contents of the PIP image and Main image Selecting a Signal Source Antenna or Cable for PIPSelecting a Signal Source External A/V for PIP Changing the PIP Channel Changing the Location Rotating the PIP WindowFreezing the PIP Image Changing the Size of the PIP WindowPress CH six times to select the V-chip menu Press VOL+ Using the V-ChipSetting Up Your Personal ID Number PIN How to Enable/Disable the V-Chip How to Set up Restrictions Using the TV guidelinesTV-Y Young children TV-Y7 Children 7 and over General audienceParental guidance TV-14E C I a L F E AT U R E S NC-17 Identifying Problems Chapter FiveSpecifications Cleaning and Maintaining Your TVUsing Your TV in Another Country