Samsung TXN2771HF/TXN3071WHF manual E C I a L F E AT U R E S

Page 69

S P E C I A L F E AT U R E S

3

The “V-chip” screen will appear.

Press the ▼ button to select “MPAA rating”, then press the ENTER but- ton.

4

The “MPAA rating” screen will appear.

Repeatedly press the ▼ button to select a particular MPAA category. Pressing the ▼ button will cycle through the MPAA categories:

GGeneral audience (no restrictions).

PG Parental guidance suggested.

PG-13PG-13 (Parents strongly cautioned).

RR (Restricted. Children under 17 should be accompanied by an adult).

NC-17No children under age 17.

XX (Adults only).

NR Not rated.

While a particular category is selected, press ENTER to activate it.

A letter (“U” or “B”) will be displayed. Press the ▲ or ▼ button to select “U” or”B”.

Press the MENU button to save the settings and to clear all screens.

Note: The V-Chip will automati- cally block any category that is “more restrictive.” For example, if you block the “PG-13” category, then “R,” “NC- 17,” and “X” will automatically be blocked also.

How to Reset the TV after the V-Chip

Blocks a Channel (“Emergency Escape”)

If the TV is tuned to a restricted channel, the V-Chip will block it. The screen will go blank and the following message will appear: “Excessive rating.”

To resume normal viewing, tune to a different channel using the number buttons. Under certain conditions (depending on the rating of the local TV programs) the V-Chip might lock out all the channels. In this case, use the V-Chip function for an “emergency escape”:

Press the MENU button to display the menu. Press the ▼ button to select the “Setup” menu and press the ENTER button.

Press the ▼ button to select the “V-chip” menu and press the ENTER button. Enter your PIN number, and press the button to temporarily disable the V-Chip Lock.

69

Image 69
Contents AA68-02942A-00 Owner’s InstructionsAs an Energy Star Partner Thank You for Choosing Samsung Example Antenna Grounding Page Installation Your New TVOperation Special Features TroubleshootingAppendix Chapter One List of FeaturesFront Panel Buttons Familiarizing Yourself with The TVVOL , + Remote Control Sensor Standby indicator¨ CH and CH Side Panel Jacks∏ VHF/UHF jack Rear Panel JacksOutput jacks Output jackMode Remote Control¨ Number buttons +100Reset Remote Control ¿ TV/Component¸ DNIe ˛ VCR ControlsAntennas with 300-ohm Flat Twin Leads Connecting VHF and UHF AntennasAntennas with 75-ohm Round Leads Connecting Cable TVSeparate VHF and UHF Antennas Cable without a Cable BoxConnecting to a Cable Box that Descrambles All Channels Connecting to a Cable Box that Descrambles Some ChannelsConnect this cable to a two-way splitter Install AT I O N Unplug the cable or antenna from the back of the TV Connecting a VCRConnecting an S-VHS VCR Make sure the jacks you are using are underneath the numberConnecting a Second VCR to Record from the TV Connecting a DVD Player 480i/480pConnecting to Y,Pb,Pr Connecting a Digital TV Set-Top Box 480p/1080iInstall AT I O N Connecting a Camcorder Installing Batteries in the Remote Control Press the Power button on the remote control Plug & Play FeatureTurning the TV On and Off Message Plug & Play is displayedSelect the Setup menu and press the Enter button If you want to reset this featureViewing the Menus and On-Screen Displays Viewing the MenusViewing the Display Selecting a Menu Language Selecting the Video Signal-source Memorizing the ChannelsPress the Menu button to display the menu Storing Channels in Memory Automatic Method Press the Menu button Adding and Erasing Channels Manual MethodChanging Channels Adjusting the VolumeButton to select Channel Labeling the ChannelsSetting the Clock Option 1 Setting the Clock ManuallyOr button repeatedly until the correct hour appears E R AT I O N E R AT I O N √ button increases it Press the Menu button to exit Customizing the PictureUsing Automatic Picture Settings TXN2798HF/ TXN3098WHF/ TXN3298HF models Customizing the SoundUsing Automatic Sound Settings Viewing an External Signal Source Setting Up Your Remote Control to Operate Your VCR or DVD Customizing Your Remote ControlDVD Codes VCR CodesSetting Up Your Remote Control to Operate Your Cable Box Cable BoxCodes Press the button to select Fine tune Fine Tuning ChannelsPress the button to select LNA LNA Low Noise Amplifier TXN2798HF/TXN3098WHF/TXN3298HFPress the button to select Tilt TiltDNIeTM Digital Natural Image engine Press button to select Digital NR Digital Noise ReductionChanging the Screen Size TXN3271HF/TXM2771HF/TXN3298HF/TXN2798HF/TXN3275HFPress the P.SIZE button to change the screen Changing the Color Tone Freezing the Picture Using the R.Surf FeatureWhen finished, press Menu button Setting the On/Off TimerSetting the Sleep Timer Choosing a Multi-Channel Sound MTS Soundtrack Auto Volume Surround Melody Viewing Closed Captions Activating Picture-in-Picture Viewing Picture-in-Picture TXN2798HF/TXN3098WHF/TXN3298HFTV, AV1, AV2 and AV3 Press the Menu button to exit Selecting a Signal Source External A/V for PIPChanging the Size of the PIP Window Swapping the Contents of the PIP image and Main image Changing the PIP Channel Using the V-Chip USA Setting Up Your Personal ID Number PINDigits for your PIN and enter them How to Set up Restrictions Using the TV guidelines How to Enable/Disable the V-ChipParent Guidance General audienceTV-14 Mature audienceEnter Pin screen will appear. Enter your 4-digit PIN number E C I a L F E AT U R E S Using the V-Chip Canada How to Enable/Disable the V-Chip TV-G Enter Pin screen will appear. Enter your 4-digit PIN number Appear. Enter your 4-digit PIN number How to Set up Restrictions Using the Canadian EnglishHow to Set up Restrictions Using Canadian French Programming intended for children under ageEnter Pin screen will appear. Enter your 4-digit PIN number Talk shows, music videos, and variety programming TXN2798HF/TXN3098WHF/TXN3298HF Viewing the DemonstrationChapter Five Identifying ProblemsCleaning and Maintaining Your TV Using Your TV in Another CountrySpecifications M O