Quick Setup Guide
Step Getting Connected
Step Select one of the following three types of connections:
Step
Getting Connected
Step
Setup
Step
Basic Operation
This Recorder will only record on
Antenna + DVD Recorder + TV : No Cable Box
Antenna +
Antenna + Cable Box + DVD Recorder + TV
The VHF/UHF RF OUT jack of this product sends only signals received through the antenna. It does not output audio/video signals. You must use one of the following connections on this unit.
Antenna + DVD Recorder + TV : No Cable Box
Connect the signal source to the DVD
Recorder
Use a TV antenna or coaxial cable to connect the signal source coming from the antenna or wall to the VHF/UHF
Connect the DVD Recorder to the TV
Use the supplied RF cable to connect
DVD Recorder to the ANT jack on the TV. Then use the
Video/Audio Cable to connect ANALOG AUDIO
OUT(R/L)/VIDEO OUT jacks on the DVD Recorder to the
Audio & Video jacks on the TV.
● For better picture quality, if your TV has an
● For the best picture quality, if your TV has Component video jacks, you can use component cables instead of the yellow video connector on the Video/Audio cable. Set the Component video out select switch on the back of your DVD recorder to 480p/480i video output mode. If your TV supports progressive scan, select 480p.
If you have an AV amplifier
Connect either audio cables from the ANALOG AUDIO OUT jacks on the DVD Recorder to the LINE IN jacks on your AV amplifier, or a digital cable from the DIGITAL AUDIO OUT (COAXIAL or OPTICAL) jack on the DVD Recorder to the DIGITAL AUDIO IN jack on your AV amplifier.
C Samsung Electronics | 1 | Printed in Korea |
|