Samsung HPN4239 manual Wall Installation Instructions, Installation Notes, Wall attachment panel

Page 8

Wall Installation Instructions

Installation Notes

1 Do not install the PDP in any location other than a vertical wall.

To protect the performance of the PDP and prevent problems, avoid the following

2 places.

•Do not install next to smoke and fire detectors.

•Do not install in an area subjected to vibration.

•Do not install in an area subjected to high voltage.

•Do not install near or around any heating apparatus.

3 Use only recommended parts and components.

Parts (Wall attachment panel is sold separately. Check with your dealer)

Wall attachment panel

Insulation holders ; 4 EA

Screws ; 4 EA

Fixing the PDP panel to the wall attachment panel bracket

1 Remove the screws on the rear of the PDP panel.

Removing four screws

2 Connect Insulation holders to screws. (see the illustration below)

3 Tighten the screws connected to the Insulation holders on the rear of the PDP panel.

Connecting four screws

14

15

Image 8

Contents Owner’s Instructions Important Safety Instructions Important Safety Information Thank You for Choosing SamsungWarranty User InstructionsScreen Image retention Cell DefectTable of Contents General InformationYour New Plasma Display Panel Remote Control Buttons Wall attachment panel Wall Installation InstructionsInstallation Notes Changing the angle How to Adjust Mounting AngleFactory default Connections Cable with a Cable Box that Descrambles All Channels Connecting VHF and UHF Antennas Connecting Cable TVAntennas with 75-ohm Round Leads Cable without a Cable Box Connecting Speakers How to ConnectConnecting a VCR Connecting a CamcorderConnecting a VCR to the Video or S-Video/Audio jack Viewing camcorder tapesPlaying DVD Watching DTVTo Play DVD To Watch DTVOperation Turning the PDP On and Off Viewing the Menus and DisplaysViewing the Menus Displaying Status InformationSelecting the Video Signal-source Memorizing the ChannelsStoring Channels in Memory Automatic Method ChannelAdd / Delete Ch. ScanSetting Up Your Remote Control Adjusting the VolumeUsing Mute Changing ChannelsSource Setting the Signal SourceRemote Control Codes Picture Control Edit NameCustom Customizing the PicturePicture Selecting the Color Tone DNIe Digital Natural Image engineChanging the Screen Size Freezing the PictureSelecting the PIP Screen Selecting an External SignalViewing the Picture-in-Picture Source Selecting a Signal Source Antenna or Cable for PIP Changing the Location of the PIP ImageSound Control Changing the PIP ChannelCustomizing the Sound Using Automatic Sound Settings SoundChoosing a Multi-Channel Sound MTS Soundtrack Using Dolby Virtual Using a Subwoofer Item.This sets the volume for the subwooferChannel Control Fine Tune Fine Tuning ChannelsLNA Low Noise Amplifier Connecting a PC and Operation Connecting to a PC Pin ConfigurationSetting up Your PDP Plug and Play To watch the PC screenHow to Set up Your PC Software Windows only Adjusting the PC Screen Adjusting the R.G.BSetup Select Setup, then press the Enter button Color ControlPicture Quality Adjustment Picture Automatic Adjustment Coarse AdjustmentSetup Image LockInformation Fine Tuning FineInformation Time Setting Setting the Sleep Timer TimeClock SleepSetting the Timers On TimeFunction Description Caption ConfigurationSelecting a Menu Language Viewing Closed Captions Setting Auto Power Off Digital Noise ReductionChip Selecting the Film ModeUsing the V-Chip TV GuideLines How to Enable/Disable the V-ChipHow to Set up Restrictions using the TV guidelines TV-G through TV-MA everybody else Mpaa RatingAppendix Troubleshooting Care and MaintenanceSpecifications Memo 102 103