Samsung HPN4239 manual Appendix

Page 49

How to Reset the TV after the V-Chip Blocks a Channel (“Emergency Escape”)

If the TV is tuned to a restricted channel, the V-Chip will block it. The screen will go blank and the following message will appear: “Excessive rating”.

To resume normal viewing, tune to a different channel using the number buttons.

Under certain conditions (depending on the rating of the local TV programs) the V-Chip might lock out all the channels. In this case, use the V-Chip function for an “emergency escape”:

Press the MENU button. Press the ▲ or ▼ button to select “Setup”, then press the ENTER

1 button.

2 Press the ▲ or ▼ button to select “V-Chip”, then press the ENTER button.

3 Enter your PIN number, and press the button to temporarily disable the V-Chip Lock.

P L A S M A D I S P L A Y

P A N E L

Appendix

Troubleshooting

98

Care and Maintenance

99

Specifications

100

96

Image 49
Contents Owner’s Instructions Important Safety Instructions Thank You for Choosing Samsung Important Safety InformationUser Instructions WarrantyScreen Image retention Cell DefectGeneral Information Table of ContentsYour New Plasma Display Panel Remote Control Buttons Installation Notes Wall Installation InstructionsWall attachment panel Factory default How to Adjust Mounting AngleChanging the angle Connections Antennas with 75-ohm Round Leads Cable without a Cable Box Connecting VHF and UHF Antennas Connecting Cable TVCable with a Cable Box that Descrambles All Channels How to Connect Connecting SpeakersConnecting a Camcorder Connecting a VCRConnecting a VCR to the Video or S-Video/Audio jack Viewing camcorder tapesWatching DTV Playing DVDTo Play DVD To Watch DTVOperation Viewing the Menus and Displays Turning the PDP On and OffViewing the Menus Displaying Status InformationMemorizing the Channels Selecting the Video Signal-sourceStoring Channels in Memory Automatic Method ChannelCh. Scan Add / DeleteAdjusting the Volume Setting Up Your Remote ControlUsing Mute Changing ChannelsRemote Control Codes Setting the Signal SourceSource Edit Name Picture ControlPicture Customizing the PictureCustom DNIe Digital Natural Image engine Selecting the Color ToneFreezing the Picture Changing the Screen SizeViewing the Picture-in-Picture Selecting an External SignalSelecting the PIP Screen Source Changing the Location of the PIP Image Selecting a Signal Source Antenna or Cable for PIPChanging the PIP Channel Sound ControlSound Customizing the Sound Using Automatic Sound SettingsChoosing a Multi-Channel Sound MTS Soundtrack Item.This sets the volume for the subwoofer Using Dolby Virtual Using a SubwooferChannel Control LNA Low Noise Amplifier Fine Tuning ChannelsFine Tune Connecting a PC and Operation Pin Configuration Connecting to a PCSetting up Your PDP Plug and Play To watch the PC screenHow to Set up Your PC Software Windows only Adjusting the R.G.B Adjusting the PC ScreenSetup Select Setup, then press the Enter button Color ControlPicture Automatic Adjustment Coarse Adjustment Picture Quality AdjustmentSetup Image LockInformation Fine Tuning FineInformation Time Setting Time Setting the Sleep TimerClock SleepOn Time Setting the TimersFunction Description Selecting a Menu Language Viewing Closed Captions ConfigurationCaption Digital Noise Reduction Setting Auto Power OffUsing the V-Chip Selecting the Film ModeChip How to Set up Restrictions using the TV guidelines How to Enable/Disable the V-ChipTV GuideLines Mpaa Rating TV-G through TV-MA everybody elseAppendix Care and Maintenance TroubleshootingSpecifications Memo 102 103