Using the Key Lock
When setting Key Lock ON, the buttons (SOURCE, MENU, VOLUME, SELECT, MUTE, POWER) on the front of the PDP don’t operate. But those buttons will operate when setting Key Lock OFF.
| Press the Menu button. Move the joystick up or |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||
1 down to select the “SETUP”, then press the joystick |
|
|
|
| SETUP |
|
| |||
|
|
|
|
|
|
|
| |||
| to enter. |
|
|
|
|
|
|
| ||
|
| Language |
| English |
|
| ||||
|
|
|
|
| Multi Control |
|
|
|
| |
|
|
|
|
| Key Lock |
| Off |
|
| |
|
|
|
| Move | Adjust | Exit |
|
| ||
|
|
|
|
|
| |||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Setting up Your Remote Control
This PDP's remote control can operate almost any VCR, cable box, or DVD. After it has been set up properly, your remote control can operate in four different modes: VCR, Cable, or DVD. Pressing the corresponding button on the remote control allows you to switch between these modes, and control whichever piece of equipment you choose.
Note:The remote control might not be compatible with DVD Player, VCR, Cable box and others manu- factured by another company.
Setting Up the Remote to Operate Your VCR, Cable box, or DVD players
1 Turn off your VCR. (or Cable box, DVD players.)
Move the joystick up or down to select the “Key
2 Lock”, then move the joystick left or right to select “On” or “Off”.
SETUP
Language | English |
Multi Control |
|
Key Lock | On |
Move | Adjust | Exit |
Press the MODE button and make sure that the VCR
2 (or Cable box, DVD) LED is illuminated.
S.Sel
3 Press the Menu button to exit.
3 Press the Set button on your PDP's remote control.
Using the number buttons on your remote control,
4 enter three digits of the VCR (or Cable box, DVD) code listed on page 64 of this manual for your brand of VCR (or Cable box, DVD players). Make sure you enter three digits of the code, even if the first digit is a "0".
(If more than one code is listed, try the first one.)
Press the Power button on the remote control.
5 Your VCR (or Cable box, DVD players) should turn on if your remote is set up correctly. If your VCR (or Cable box, DVD players) does not turn on after set up, repeat steps 2, 3, and 4, but try one of the other codes listed for your brand of VCR (or Cable box, DVD players).
If no other codes are listed, try each code, 000 through 089 (or Cable box: 0000 through 077, DVD players: 000 through 008).
Notes
•When your remote control is in “VCR” mode, the VCR control buttons (Stop, REW, Play/Pause, FF) still operate your VCR.
•When your remote control is in “Cable box” or “DVD” mode, the VCR control buttons (Stop, REW, Play/Pause, FF) still operate your VCR.
60 | 61 |