Regulatory Compliance Statements
- - - - - -
Federal Communications Commission (FCC) - USA | |
Industry Canada Equipment Standard for | Digital Equipment |
Voluntary Control Council for Interference | (VCCI) - Japan |
Bureau of Standards Metrology and Inspection (BSMI) - Taiwan | |
Korea Communications Commission(KCC) - Republic of Korea | |
Italian Post Ministry (Homologation) - Italy |
|
- Canada
FCC Class A Notice
This
device complies
with part
15
of
the FCC Rules.
Operation
is
subject
to
the
following
two
conditions:
1.
This
device may not cause harmful interference, and
2.
This
device must
accept
any
interference
received,
including interference that
may
cause undesired operation.
®
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.
FCC
Class B Notice
This
device
complies
with
part
15
of
the
FCC
Rules.
Operation is subject to
the following
two
conditions:
®
- - - -
1. | This device may not cause harmful interference, and |
2. | This device must accept any interference received, including interference that may cause undesired operation. |
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC | |
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This | |
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, | |
may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a | |
particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by | |
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: | |
Reorient or relocate the receiving antenna. | |
Increase the separation between the equipment and receiver. | |
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. | |
Consult the dealer or an experienced radio/TV technician for help. | |
·User Information
Changes or equipment.
modifications not expressly approved by the party responsible for compliance could void the user'sauthority If necessary, consult with your dealer or an experienced radio/television technician for additiona suggestions.
to operate the You may find the
booklet
called
How
to
Identify
and
Resolve
Radio/TV
Interference
Problems
helpful.
This
booklet
was
prepared
by
the
Federal
Communications
Commission.
It
is
available
from
the
U.S.
Government
Printing
Office
.
Washington,
DC
20402,
Stock
Number
The
party
responsible
for
product
compliance:
SAMSUNG ELECTRONICS CO., America QA Lab of Samsung
LTD
.
33
51
Michelson
Drive
Suite
#290,
Irvine,
CA92612
USA
~~~~~~Q
________________________________________________________________________________
_
User must use shielded signal interface cables to maintain FCC compliance for the product. Provided with this monitor is a detachable power supply cord with IEC320 style terminations. It may be suitable for connection to any UL Listed personal computer with similar configuration. Before making the connection, make sure the voltage rating of the computer convenience outlet is the same as the monitor and that the ampere rating of the computer convenience outlet is equal or exceeds the monitor voltage rating. For 120 Volt applications, use only UL Listed detachable power cord with NEMA configuration