Samsung LTN325W manual FCC Information

Page 4

BN68-00448A-03Eng_01 10/6/03 11:03 AM Page 3

FCC Information

User Instructions

The Federal Communications Commission Radio Frequency Interference Statement includes the following warning:

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a resi- dential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guar- antee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television receptions, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the inter- ference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

User Information

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. If necessary, consult your dealer or an experi- enced radio/television technician for additional suggestions. You may find the booklet called How to Identify and Resolve Radio/TV Interference Problems helpful. This booklet was prepared by the Federal Communications Commission. It is available from the U.S. Government Printing Office, Washington, DC 20402, Stock Number 004-000-00345-4.

The party responsible for product compliance:

SAMSUNG ELECTRONICS CO., LTD America QA Lab of Samsung

3351 Michelson Drive,

Suite #290, Irvine, CA92612 USA

Warning

User must use shielded signal interface cables to maintain FCC compliance for the product. Provided with this monitor is a detachable power supply cord with IEC320 style terminations.

It may be suitable for connection to any UL Listed personal computer with similar configuration. Before making the connection, make sure the volt- age rating of the computer convenience outlet is the same as the monitor and that the ampere rat- ing of the computer convenience outlet is equal to or exceeds the monitor voltage rating.

For 120 Volt applications, use only UL Listed detachable power cord with NEMA configuration

5-15P type (parallel blades) plug cap. For 240 Volt applications use only UL Listed Detachable power supply cord with NEMA configuration 6015P type (tandem blades) plug cap.

IC Compliance Notice

This Class B digital apparatus meets all require- ments of the Canadian nterference-Causing Equipment Regulations of ICES-003.

Cet appareil Numérique de classe B respecte toutes les exigences du Règlemont NMB-03 sur les équipements produisant des interférences au Canada.

Notice de Conformité IC

Cet appareil numérique de classe B respecte toutes les exigences du Règlement ICES-003 sur les équipements produisant des interférences au Canada.

VCCI

This is a Class B product based on the standard of the Voluntary Control Council for Interference by Information Technology Equipment (VCCI). If this is used near a radio or television receiver in a domestic environment, it may cause radio interfer- ence. Install and use the equipment according to the instruction manual.

This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numéique de la classe B estconforme à la norme NMB-003 du Canada.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1)This device may not cause harmful interference, and

(2)This device must accept any interference received, including interference that may cause unesired operation. This television receiver provides display of television closed captioning in accordance with §15.119 of the FCC rules.

SAFETY 3

Image 4
Contents Owner’s Instructions Safety Instructions BN68-00448A-03Eng01 10/6/03 1103 AM FCC Information BN68-00448A-03Eng01 10/6/03 1103 AM Memo Installation Special FeaturesYour New TV OperationPC Display TroubleshootingAppendix List of Features List of PartsFront Panel Buttons Familiarizing Yourself with Your New TVVOL + Rear Panel Jacks CH and CH Channel Up/Down Remote ControlVOL + and VOL +100 DNIe ButtonInstalling Batteries in the Remote Control Remote control doesn’t workConnecting VHF and UHF Antennas Antennas with 300-ohm Flat Twin LeadsConnecting Cable TV Antennas with 75-ohm Round LeadsSeparate VHF and UHF Antennas Cable without a Cable BoxConnecting to a Cable Box that Descrambles All Channels Connecting to a Cable Box that Descrambles Some ChannelsEnglish-10 Connecting a VCR Connecting an S-VHS VCR Connecting an External Input SourceConnecting a DVD Player Connecting a Digital TV Set-Top BoxHow to Connect Connecting the SpeakersHow to Turn the Sound On Connecting a PC SUBAdjusting the Volume Using the Channel ButtonsUsing the PRE-CH Button to select the Previous Channel Turning the TV On and OffViewing the Display Using MuteViewing the Menus Setting Up Your Remote Control Setting Up the Remote to Operate Your VCRSetting Up the Remote to Operate Your Cable Box Setting Up the Remote to Operate Your DVD Remote Control Codes Plug & Play Feature Chapter FourSelecting the Video Signal-source Memorizing the ChannelsStoring Channels in Memory Automatic Method To select channels overTo Select TV/Input Adding and Erasing Channels Manual MethodTo Edit the Input Source Name Using Automatic Picture Settings Alternate methodCustomizing the Picture Using Automatic Sound Settings Customizing the Sound Selecting a Menu Language Setting the Blue Screen Mode To Select an External Output Device LNA Low Noise Amplifier Fine Tuning Channels Viewing Picture-in-Picture PIP SettingsActivating Picture-in-Picture Changing the PIP Channel Swapping the Contents of the PIP and Main imageChanging the Size of the PIP Window Changing the Screen Size Freezing the PictureAdjusting the Background Color Setting the DNIe To Enjoy Dolby Digital Sound Turning the Dolby Pro-Logic II OnTurning the Dynamic Range On Speaker Settings SpeakerLevel Time Delay Trademark & Label License Notice Changing the Stereo Settings You can select either Main or Sub when PIP is On Selecting the Main or Sub SoundTo Select an External Input Device Adjusting the Headphone Sound Setting the Clock Setting the On/Off Timer What is Absent Power Off? Setting the Sleep Timer Setting the On/Off Timer Using the MenuUsing the V-Chip Setting Up Your Personal ID Number PINHow to Enable/Disable the V-Chip How to Set up Restrictions Using the ‘TV guidelines’TV-Y English-58 NC-17No children under age Adults only NR Not rated Using Your TV as a Computer PC Display How to Set up Your PC Software Windows onlyAdjusting the Screen Quality Changing the Screen Position Use to return the screen settings to the default values To Initialize the Screen SettingsChoose the right DVI signal for your computer How to DVI SelectHow to Auto Adjust Identifying Problems Chapter SixEnglish-67 Installing Stand Maintenance of Your LCD TVUsing the Anti-Theft Kensington Lock OptionalList of Contents How to Attach the LCD TV to the Bracket Using Your TV in Another Country Cleaning and Maintaining Your TVPin Assignments Specifications LTN325W LTN406WDisplay Modes Clock Sync Polarity ModeFrequency KHz MHz
Related manuals
Manual 81 pages 50.35 Kb