Samsung LTN 1735, LTN 1535 Connecting VHF and UHF Antennas, Antennas with 300-ohm Flat Twin Leads

01-12_EN 6/26/03 2:41 PM Page 6

Chapter Two

I N S TA L L AT I O N

Connecting VHF and UHF Antennas

If your antenna has a set of leads that look like this, see “Antennas with 300-ohm Flat Twin Leads”, below.

If your antenna has one lead that looks like this, see “Antennas with 75-ohm Round Leads”, on page 7.

If you have two antennas, see “Separate

VHF and UHF Antennas”, on page 7.

Antennas with 300-ohm Flat Twin Leads

If you are using an off-air antenna (such as a roof antenna or “rabbit ears”) that has 300-ohm twin flat leads, follow the directions below.

1

Place the wires from the twin leads under the screws on a 300- 75 ohm adaptor (not supplied). Use a screwdriver to tighten the screws.

2

Plug the adaptor into the TV ANTENNA terminal on the bottom of the back panel.

English-6