OP E R AT I O N
Storing Channels in Memory (Automatic Method)
1
First, select the correct signal source (Air, STD, HRC, IRC). See steps 1~2 on previous page.
Press the MENU button.
Press the
UP/DOWN
buttons
to select “Channel”, then press the ENTER 
button.
2
Press the
UP/DOWN 
buttons
to select “Auto Program”. Press the ENTER 
button.
3
Press the ENTER 
button.
The TV will begin memorizing all of the available channels.
4
After all the available channels are stored, the Auto Program menu reappears.
Press the EXIT button to exit.
To check the channels stored in memory
Press the CH 
/ 
button.
Only the channels stored in memory are selected.
The TV automatically cycles through all of the available channels and stores them in memory. This takes about one to two minutes.
Press ENTER 
at any time to interrupt the memorization process and return to the CHANNEL menu.
Note: You can also press the AUTO PROG. button to select available channels.
To select channels over 100
Ex) Press 
to select channel 108.