Other Information
Issues | Solutions and Explanations |
Others |
|
|
|
The cable/set top box remote control | • Program the Cable/Sat remote control to operate the TV. Refer to the Cable/Sat user manual |
does not turn the TV on or off, or adjust | for SAMSUNG TV code. |
the volume. |
|
|
|
‘Mode Not Supported’ message. | • Check the supported resolution of the TV and adjust the external device’s output resolution |
| accordingly. Refer to resolution settings in this manual. |
|
|
Caption on TV menu is greyed out. | • Caption can not be selected in the TV menu when connected via HDMI or Component. |
| • Caption must be activated on the external device. |
|
|
There is a plastic smell from the TV. | • This smell is normal and will dissipate over time. |
|
|
TV Signal Strength is unavailable in the | • This function is only available with digital channels with an Antenna (RF/Coax) connection (Air |
Self Diagnosis Test menu. | or Cable). (P. 20) |
|
|
TV is tilted to the right or left side. | • Remove the stand base from the TV and reassemble. |
|
|
Channel menu is grey out (unavailable). | • Channel menu is only available when the TV source is selected (Antenna or Cable). |
|
|
Your settings are lost after 30 minutes | • If TV is in the Store Demo mode, it will reset audio and picture settings every 30 minutes. |
or every time the TV is turned off. | Please change from Store Demo mode to Home Use mode in the Plug & Play procedure. |
| Press the SOURCE button to select TV mode, go to MENU → Setup → Plug & Play → |
| ENTERE. |
|
|
You have intermittent loss of audio or | • Check the cable connections and reconnect them. |
video. | • Loss of audio or video can be caused by using overly rigid or thick cables. Make sure the |
| |
| cables are flexible enough for long term use. Mounting the TV to the wall, we recommend using |
| cables with 90 degree connectors. |
|
|
You see small particles when you look | • This is part of the product’s design and is not a defect. |
closely at the edge of the frame of the |
|
TV. |
|
|
|
POP (TV’s internal banner ad) appears | • Select Home Use under Plug & Play mode. |
on the screen. | For details, refer to Plug & Play (Initial Setup). (P. 7) |
|
|
✎✎Watch these troubleshooting on video at www.samsung.com/spsn.
✎✎This TFT LCD panel uses a panel consisting of sub pixels which require sophisticated technology to produce. However, there may be a few bright or dark pixels on the screen. These pixels will have no impact on the performance of the product.
¦¦ Storage and Maintenance
✎✎If a sticker was attached to the TV screen, some debris can remain after you remove the sticker. Please clean it before watching the TV.
✎✎The exterior and screen of the product can get scratched during cleaning. Be sure to wipe the exterior and screen carefully using the cloth provided or a soft cloth to prevent scratches.
Do not spray water directly onto the product. Any liquid that goes into the product may cause a failure, fire, or electric shock.
32 English
Clean the product with a soft cloth dampened with in a small amount of water. Do not use a flammable liquid (e.g. benzene, thinners) or a cleaning agent.
11:19:11