Connecting VHF and UHF Antennas, Tv R, Rfa/B

Connecting VHF and UHF Antennas

Antennas with 300 Q Flat Twin Leads

If you are using an air antenna(such as a roof antenna or "rabbit ears") that has 300 £_twin fiat leads, follow the directions below.

1Place the wires from the twin leads under the screws on a 300-75 _ adapter(not supplied). Use a screwdriver to tighten the screws.

2Plug the adaptor into the ANT IN terminal on the back of the TV. Antennas with 75 Q Round Leads

1 Plug the antenna lead into the ANT IN terminal on the back of the TV.

Separate VHF and UHF Antennas

If you have two separate antennas for your TV(one VHF and one U HF), you must combine the two antenna signals before connecting the antennas to the TV. This procedure requires an optional combiner-adaptor(available at most electronics shops).

1 Connect both antenna leadsto the combiner.

2 Plug the combiner into the ANT IN terminal on the back of the TV.

ANT IN

Connecting Cable TV

Cable without a Cable Box

1 Plug the incoming cable into the ANT IN terminal on the back of the TV.

Because this TV is cable-ready, you do not need a cable box to view unscrambled cable channels.

a Cable Box that Descrambtes All Channels

1Find the cable that is connected to the ANT OUT terminal on your cable box. This terminal might be labeled "ANT OUT", "VHF OUT" or simply, "OUT".

2 Connect the other end of this cable to the ANT IN terminal on the back of the TV.

to a Cable Box that Descrambles Some Channels

If your cable box descrambles only some channels(such as premium channels), follow the

instructions below. You will need a two-way splitter, an RF (A/B) switch, and four lengths of Antenna cable. These items are available at most electronics stores.)

ANT IN

%	IN	CABL
		cable	_ _	_	_	_	_l =""_.\,_./,_		TV R
	Cable Box		Splitter		] "''_L	J_	[	RF(A/B)	ear
	Cable Box				CableBox			Switch
					CableBox			Switch

1Find and disconnect the cable that is connected to the ANT IN terminal on your cable box.

This terminal might be labeled 'ANTIN , "VHF IN" or simply, "IN".

2Connect this cane to a two-way splitter.

3Connect an Antenna cable between an OUT terminal on the splitter and the iN terminal on the cable box.

4Connect an Antenna cable between the ANT OUT terminai

on the cable box and the B-IN terminai on the RF(A/B) switch.

5Connect another cable between the other OUT terminal on the splitter and the A-IN terminal on the RF (A/B) switch.

6Connect the last Antenna cable between the OUT terminal on

the RF (A/B) switch and the ANT IN terminal on the back of the TV.

After you have made this connection, set the A/B switch to the 'W' position for normal viewing. Set the A/B switch to the "B' position

to view scrambled channels. (When you set the A/B switch to "B", you wilt need to tune your TV to the cable box'soutput channel, which is usually channel 3 or4.)

Connecting VHF and UHF Antennas

Connecting Cable TV

TV R

RF(A/B)