How to Install the Wall Mount Bracket
Instructions on Securing the SET to the Wall Mount Bracket
➢The exterior of the SET may be different than the picture. (Assembly and installation of the plastic hanger is the same.)
1Remove the screws from the back of the PDP.
3Tighten the screws of the plastic hanger (shown in picture 2) to the back side of the PDP.
2Use the screw and assemble the plastic hanger. (Please refer to the following picture.)
☛1 Please ask the installers to install the wall mount bracket.
2Please be sure to check if the plastic hanger is completely secured on both the left and right side after hanging the SET on the wall mount bracket.
3Please avoid catching your fingers while installing and adjusting the angle.
4Please tightly secure the wall mount bracket to the wall to avoid injury from a falling SET.
4Remove the Safety Pins. Fasten the 4 plastic latches assembled at step (#) on the back side of the PDP using the guide holes of the wall mount, push (!) and hook (@) down to secure the PDP on the wall mount as illustrated. Secure the PDP by inserting the Safety Pins, not to fall from the wall mount.
PDP panel
Wall attachment | Wall |
panel bracket |
|
How to Adjust Mounting Angle
➢Please secure the mounting bracket on the wall surface after setting its angle at 0°
1Secure the SET to the wall mount bracket.(Please refer to the follow ing instructions.)
2Set the angle by pulling the upper end of the SET attached to bracket in the direction of the arrow. (Refer to the illustration on the right.)
3The angle can be adjusted from 0° to 15° by ±2°.
continued...
Hold onto the middle of the PDP to adjust the angle (not the sides of the PDP).
English - 37