Samsung PS-42D4S manual Connecting to an Aerial or Cable Television Network, Rear of the PDP

Connecting to an Aerial or Cable Television Network

ENG

Rear of the PDP

or

Cable Television

Network

To view television channels correctly, a signal must be received by the set from one of the following sources:

◆An outdoor aerial

◆A cable television network

◆A satellite network

1 In the first three cases, connect the aerial or network input cable to the 75Ω coaxial socket on the rear of the PDP.

2If you are using an indoor aerial, you may need to turn it when tuning your PDP until you obtain a picture that is both sharp and clear.

For further details, refer to:

◆“Storing Channels Automatically” on page 19

◆“Storing Channels Manually” on page 20

➢When installing or re-installing your PDP, be sure to use the supplied coaxial antenna cable. If you connect using a different coaxial cable, there is risk of noise or interference to the screen image. (You must not use another general purpose cable.)

Connecting a Satellite Receiver or Decoder

Rear of the PDP

Satellite receiver/

Decoder

14

In order to watch television programmes broadcast via a satellite network, you must connect a satellite receiver to the rear of the PDP. Also, in order to descramble a coded transmission signal, you must connect a decoder to the rear of the PDP.

Using a Coaxial cable

Connect a coaxial cable to the:

◆Receiver (or Decoder) output socket.

◆Television aerial input socket.

➢If you wish to connect both a satellite receiver (or decoder) and a VCR, you should connect the:

◆Receiver (or Decoder) to the VCR

◆VCR to the PDP

Otherwise, connect the receiver (or decoder) directly to the PDP.